Powering ON/OFF
3) | 4) | 2) | 1) |
|
| 1) | 2) |
|
|
|
Basic Operation
Powering off the projector
1111 Press POWER STANDBY (
).
2222 Press ◄► to select [OK] and press (ENTER).
(or press POWER STANDBY (
) again.)
The projection of the image stops, and [Power indicator] lamp of the main unit lights up orange. (The cooling fan keeps running.)
3333 Wait until the power indicator lamp of the main unit turns to red (i.e., until the cooling fan stops).
4444 Press the [
] marked side of the (MAIN POWER) switch to remove all power from the projector.
Note
zz In the cooling state after the power is turned off, the lamp will not light up even if the power is turned on. To light up the lamp, turn on the power supply again when the lamp has been cooled sufficiently. Failure to observe this may shorten the lamp life.
zz The projector consumes approximately 6 W (120 V mode) power.
(STANDBY MODE: [NORMAL])
Direct power off function
The power supplied internally causes the cooling fan to continue operating and cool off in the event that the power has failed or even after the power cord is accidentally disconnected immediately after the power has been turned off.
Note
zzWhen the lamp has been cooled by the direct power off function, it sometimes takes longer than usual for the lamp to light up again.
zzWhile the cooling fan is operating, do not place the projector inside a box or bag.
zzIf projection was stopped by using the DIRECT POWER OFF function, it can be started by setting the MAIN POWER switch to the “ I ” (ON) position.
40 - ENGLISH
