Settings
ADVANCED MENU
INPUT RESOLUTION
Input resolution adjustment achieves the best image when the screen flickers or halo is observed around the contour. Set the values appropriately for the signal resolution that is being used.
1111 Press ▲▼ to select [INPUT RESOLUTION].
2222 Press <ENTER> button.
zzThe [INPUT RESOLUTION] screen will be displayed.
3333 Press ▲▼ to select [TOTAL DOTS], [DISPLAY DOTS], [TOTAL LINES] or [DISPLAY LINES], and the press ◄► to adjust it.
zzEach item automatically displays a value in response to the type of the input signal. If vertical stripes appear on the screen or the image is partly missing, increase or decrease the displayed value while observing the screen to achieve the optimal value.
Note
zzThe vertical stripes will not appear on the all white signal image.
zzThe picture may be distorted during the adjusting operation, but this is not a fault.
zzThe [INPUT RESOLUTION] can be adjusted only when RGB signal input is applied with RGB1 and RGB2 IN.
CLAMP POSITION
Use the clamp position adjustment to achieve the optimal value when dark areas of the image are crushed or displayed in green.
1111 Press ▲▼ to select [CLAMP POSITION].
2222 Press ◄► to adjust.
zzThe value changes from 1 to 255.
zzThe optimal value for the clamp position adjustment
If dark areas are crushed :
The optimal value is the point where the dark area is best improved.
If the dark areas are displayed in green :
The optimal value is the point where the green areas become black and the crushing effect is rectified.
Note
zzThe [CLAMP POSITION] can be adjusted only when the RGB signal input is applied with RGB1 and RGB2 IN. zzThe [CLAMP POSITION] may not be adjusted, depending
on the signal.
EDGE BLENDING
The
1111 Press ▲▼ to select [EDGE BLENDING].
2222 Press ◄► to switch [EDGE BLENDING].
zzThe setting will change as follows each time ◄► is pressed.
OFF |
|
| ON |
| USER |
|
|
| |||
OFF |
| When the | |||
| going to be used. |
| |||
|
|
| |||
ON |
| When the default linear blending | |||
| ramps are sufficient. |
| |||
|
|
| |||
|
| When a | |||
USER |
| ramp is required. These ramps can | |||
| be defined and uploaded to the | ||||
|
| projector through the | |||
|
| Consult your dealer for details. | |||
3333 Press <ENTER> button.
zzThe [EDGE BLENDING] screen will be displayed.
4444 Press ▲▼ to specify the area to be adjusted.
zzTo blend the top edge: set [UPPER] to [ON].
zzTo blend the bottom edge: set [LOWER] to
[ON].
zzTo blend the left edge: set [LEFT] to [ON].
zzTo blend the right edge: set [RIGHT] to [ON].
5555 Press ◄► to toggle [ON] and [OFF].
6666 Press ◄► to adjust the overlap width and the starting point.
64 - ENGLISH
