VM8013HD
Menu Operation
1 2
DISP CH/
CAT
DIM
SRC | PGM |
BAND
iPod Menu
VM8013HD
INT
1 2
RPT RDM
3 4
DN UP
5 6
18
A/V IN
12/24 Mode
This option allows selection of a 12 hour or 24 hour clock format. “12 Hours” is the default setting. Turn the rotary encoder to change to the 24 hour clock format.
Mirror Image
This option allows for selection of a mirror image view when a rear view backup camera (sold separately) is connected to the CAMERA IN input on the back of the radio. Turn the rotary encoder to select “On” or “Off”.
Vol Mode
Turn the rotary encoder to select “Last” or “Adjust”.
Press and hold the VOL/SEL/MENU button (2) for more than two seconds to access the menu. Press the VOL/SEL/MENU button to move through the following menu options: Equalizer, Loud Set, Beep Set, 12/24 Mode (clock), Mirror Image, Vol Mode,
Equalizer
The Equalizer function applies preset sound effects to the unit’s audio output signal. Turn the rotary encoder to select from the following equalizer options: “Off”, “Rock”, “Hip Hop”, “Dance” and “Acoustic”. With the equalizer function activated, if bass or treble is adjusted, the EQ Mode will revert to “Off”.
When the equalizer function is activated, the most recently selected bass/ treble levels cannot be adjusted. When the equalizer function is not active, the unit will return to the most recently selected bass and treble levels.
Loud Set
When listening to music at low volumes, this feature will selectively boost certain bass and treble frequencies. “Off” is the default setting. Turn the rotary encoder to select “On”.
Beep Set
The beep tone feature allows the selection of an audible beep tone to be heard each time the menu is accessed. “On” is the default setting. Turn the rotary encoder to select “Off”.
•Last: When the unit is turned on, the volume will resume at the level selected when last turned off.
•Adjust: If choosing “Adjust”, use the
Turn-On Volume (A-VOL)
After selecting “Adjust” for Vol Mode, press the VOL/SEL/MENU button to access the
Sub LPF (Low Pass Frequency)
After connecting a subwoofer to the back of the unit, turn the rotary encoder to select a crossover frequency: OFF, 80, 120 or 160Hz.
Area Set
This option allows you to select the appropriate frequency spacing for your area. “U.S.A.” is the default setting. Turn the rotary encoder to select “EUROPE”.
Dimmer
Press the DIM button (15) on the front panel to dim the screen by 1/2. Press again to darken the screen completely. Press a third time to resume full brightness.
Clock Set
1.Press and hold the DISP button (7) until the clock blinks.
2.Turn the VOL/SEL/MENU rotary encoder (2) to set the minutes.
3.Press the VOL/SEL/MENU button (2) to confirm and move to the hour field.
4.Turn the VOL/SEL/MENU rotary encoder to set the hour.
5.Press the DISP button to set the clock and exit the clock set function.
8