Jensen VM8013HD operation manual Power Antenna

VM8013HD

WIRING NOTE: The amplifier in this radio is only designed for use with four speakers. Never combine (bridge) outputs for use with two speakers. Never ground negative speaker leads to chassis ground.

NOTE: Only connect speakers with a nominal impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit.

SAT R (Red)

(Blue)

SAT BUS

SAT L (White)

Fuse (15A)

Subwoofer Out

Parking Brake (Pink)

Camera In

Video Out 1

Video Out 2

(Yellow)

(Yellow)

(Yellow)

Camera/Active High Level Input (Green/White)

+

IPOD BUS

JXMC or XMDJEN100 Cables

(sold separately)

Antenna

)	+	Battery
-	)	Connect the yellow wire to the battery
(	(	or 12 volt power source that is always
		live. This wire MUST be connected
		for the radio to work.	FILTER
		Yellow
			BOX
		Black

Chassis Ground

SWC (Steering Wheel Control)

(Requires PAC SWI-PS Interface Adapter)

Rear Line out	R (Red)
Gray	L (White)
Front Line out	R (Red)
Black	L (White)

Power Antenna

Connect to power antenna or amplifier. If not used, tape bare end of wire.

Satellite Radio Tuner

(sold separately)

jLinkiPodCable (Included)

Connect the black wire to the factory ground wire. If a factory ground wire is not provided, locate a clean, unpainted metal part of the dash and secure the ground wire with a "ring" terminal and a sheet metal screw.

iPod	NOTE: Video playback not supported for all
(Sold Separately)	iPods. See iPod section for more information.

FRONT

White/Black	White	Gray/Black	Gray
Stripe		Stripe

Left Speaker	Right Speaker
(Front)	(Front)

Blue

Accessory/Ignition Connect to existing radio wire or radio fuse.

	Red
REAR
Green/Black	Green Purple/Black Purple
Stripe	Stripe

Left Speaker	Right Speaker
(Rear)	(Rear)

IMPORTANT!

The pink parking

wire MUST be

connected to the

switched side of the

parking break

circuit (the part that becomes grounded when the brake is applied).

3