3M MT7 manual 3M MicroTouch Software MT 7 User Guide

Page 35

3M™ MicroTouch™ Software MT 7 User Guide

35

The Installer produces a catalog file, TwTouch.pbcxml that reflects the components that are installed and could be included in a project.

Instructions for Platform Builder for Microsoft Windows® CE 6.0 R3

As installed, MT 7 should operate under the Platform Builder for Windows® CE 6.0 R3 and above without any user changes. If you open a project for a CE 6.0 device using platform builder under Catalog Item Views, you will see an entry for MT7 drivers under Third Party→ Device Drivers→ 3M Touch Systems→ MT7.

Add the MT7 drivers and the Control Panel application by selecting the check boxes next to the MT7 catalog items. Once the relevant catalog items are selected, verify that the new items appear as subprojects in the Solution Explorer (as shown in the picture below).

3M Touch Systems, Inc. Proprietary Information – 25695M

Image 35

Contents 3M MicroTouch Software MT User Guide 3M MicroTouch Software MT 7 User Guide Contents Appendix a Multiple Monitor Setup Windows Only Introduction Sensor Care and CleaningAbout This Manual Contact 3M Touch Systems 3M Touch Systems Support ServicesMT 7 Control Panel Installing MT 7 SoftwareMT 7 Software Overview Touch DriversMultiple Display Manager Installing MT 7 SoftwareOnline Help MT 7 Windows Software Uninstall Utility Calibration ToolDriver Selection User Interface Utilities and Tools Performing a Silent InstallUninstalling MT 7 Software Customizing Your SettingsOpening the MT 7 Control Panel MT 7 Software Control PanelOverview Calibration Main TabCalibrating the Sensor Controller ID Testing the CalibrationSupport Information Sensor Status Controller TypeFirmware Version Touch Modes Touch Settings TabDrawing Mode Default Value Touch Sound Touchdown ModeLiftoff Mode Right-Click Tool not available on LinuxDouble-Click Area not available on Windows CE or Linux Edge Adjustment TabDouble-Click Speed not available on Windows CE or Linux Edge Adjustment Setting 3M MicroTouch Software MT 7 User Guide Component Versions Tools TabController Restore Factory SettingsDraw Test SoftwareAdvanced Touch Options Reset ControllerController Tab Linearization Process LinearizationPen Modes Pen Overview Pen Controller OnlyPen and Finger Calibration Sensor Frequency Sensor Frequency ProcedureTesting the Newly Selected Frequency Controller ID Windows CE Overview Installation InstructionsLicense Agreement WelcomeSelect Installation Folder Installation Complete Confirm Installation3M MicroTouch Software MT 7 User Guide 3M MicroTouch Software MT 7 User Guide Slow Draw Anomalies Page MT 7 Component Selection In Target Designer Windows XP Embedded OverviewLoading MT 7 Into The Components Database Manager MT 7 Components Software Prerequisites MT 7 for Linux OverviewSystem Requirements Hardware PrerequisitesPreparation Before Driver InstallationGeneral Instructions Other Options Normal InstallationInstalling on Write-Protected Systems HotplugDir XinitDir and XinitSuffix Error Messages During InstallationCannot find needed libstdc++.so in /usr/lib Removing MT 7 For Linux Troubleshooting The Init ScriptRunning Touch Applications Troubleshooting Touch BehaviorCalibration Messages Are Unreadable Known IssuesPage Changing the Controller ID Multiple Monitor Setup Windows OnlySetting Up Multiple Monitors 3M MicroTouch Software MT 7 User Guide 3M MicroTouch Software MT 7 User Guide Page Other Serial Devices Do Not Work Troubleshooting the Touch SystemCursor Jumps or Bounces Suddenly Across the Display Multiple Display SupportCursor Does Not Reach Edges of Display Cursor is JitteryTouch Is Not Working Drawing Lines Are Not Straight and SmoothFind Sensor for Serial Plug & Play Controllers Right-click Tool Buttons Are Swapped Touch Driver Did Not LoadPrevious Version of TouchWare Software Was Detected