3M™ MicroTouch™ Software MT 7 User Guide | 5 |
About This Manual
Introduction
This manual describes how to:
∙ Install 3M™ MicroTouch™ Software MT 7 for your touc h system and specific operating system.
∙Use the MT 7 control panel to customize your work environment.
∙Troubleshoot the sensor.
Before installing MT 7 software, you must complete the appropriate hardware connections for your controller. For instructions, refer to your appropriate 3M™ MicroTouch™ Controller Reference Guide. All technic al documentation can be found on the 3M Touch Systems, Inc. website at www.3m.com/touch.
The drivers included in MT 7 will support the following: |
| |
∙ | All current 3M™ MicroTouch™ controllers (no legacy | controllers) and chipset |
| designs. |
|
∙ Capacitive and resistive touch technologies |
| |
∙ | Both USB and |
|
Sensor Care and Cleaning
The sensor requires very little maintenance. 3M Touch Systems, Inc. recommends that you periodically clean the glass surface.
CAUTION
To reduce the risk of the potentially hazardous situations associated with the use of isopropyl alcohol which may result in minor or moderate injury or property damage:
Follow all instructions and recommendations in the alcohol manufacturer's Material Safety Data Sheet and product label.
Typically, an isopropyl alcohol and water solution ratio of 50:50 is the best cleaning agent for your sensor. You can also use straight isopropyl alcohol. Be sure to follow solvent manufacturer's precautions and directions for use when using any solvents.
3M Touch Systems, Inc. Proprietary Information – 25695M