PI SEEK Setting
1 Press MENU to select the SETUP mode, then press
MODE.
SETUP mode is activated.
BASS ENGINE 
SETUP 
RETURN (OFF) 
BASS ENGINE
2 Press 
or 
to select the PI SEEK, then press MODE.
3 Turn the Rotary encoder to select ON or OFF.
4 Press MENU to select RETURN.
After 2 seconds, the unit returns to normal mode. Pressing and holding MENU for at least 2 seconds will return to normal mode.
Setting PTY31 (Emergency Broadcast) reception
Turn PTY31 (Emergency Broadcast) reception ON/OFF.
1 Press MENU to select SETUP mode, then press
MODE.
The SETUP mode is activated.
BASS ENGINE 
SETUP 
RETURN (OFF) 
BASS ENGINE
2 Press 
or 
to the select ALERT PTY31 mode, then press MODE.
3 Turn the Rotary encoder to select ON or OFF.
If you set to ON, emergency broadcasts are received regardless of source.
“ALARM” is displayed during reception.
4 Press MENU to select RETURN.
After 2 seconds, the unit returns to normal mode. Pressing and holding MENU for at least 2 seconds will return to normal mode.
When an emergency broadcast is received, the volume level will be automatically changed to the memorized level in the traffic information mode.
For details, refer to “Receiving Traffic Information” on page 12.
Setting the Time to automatically Adjust
If you set to ON, the time will be automatically adjusted by RDS data.
1 Press MENU to select the SETUP mode, then press
MODE.
SETUP mode is activated.
BASS ENGINE 
SETUP 
RETURN (OFF) 
BASS ENGINE
2 Press 
or 
to select the AUTO CLOCK mode, then press MODE.
3 Turn the Rotary encoder to select ON or OFF. 4 Press MENU to select RETURN.
After 2 seconds, the unit returns to normal mode. Pressing and holding MENU for at least 2 seconds will return to normal mode.
Receiving Traffic Information
1 Press TA so that the “TA” indicator lights up.
2 Press 
or 
to select your desired traffic information station.
When a traffic information station is tuned in, the “TP” indicator lights up.
Traffic information is heard only when it is being broadcast. If traffic information is not being broadcast, the unit is set in the standby mode. When a traffic information broadcast begins, the unit automatically receives it and the display shows
When the traffic information broadcast is over, the unit will automatically set in the standby mode.
•If the traffic information broadcast signal falls below a certain level, the unit remains in the receiving mode for 1 minute. If the signal remains below a certain level for over 1 minute, the “TA” indicator blinks.
•If you do not want to listen to the traffic information being received, lightly press TA to skip that traffic information message. The TA mode will remain in the ON position to receive the next traffic information message.
•If the volume level is changed while receiving traffic information, the changed volume level will be memorized. When traffic information is received next time, the volume level will be automatically adjusted to the level memorized.
•In the TA mode, the SEEK tuning selects only the TP stations.