Alpine DVA-9861Ri owner manual Sound Setting, Left and Right/Fader Between Front Rear/Defeat

Sound Setting

Rotary SOURCE/

encoder POWER BAND MENU

MODE

Adjusting Bass/Treble/Balance (Between

Left and Right)/Fader (Between Front

and Rear)/Defeat

1 Press MODE repeatedly to choose the desired mode.

Each press changes the modes as follows:

BASS TREBLE SUBW* BALANCE FADER DEFEAT VOLUME BASS

Bass Level: –7 ~ +10

Treble Level: –7 ~ +7

Subwoofer : 0 ~ +15

Balance : L15 ~ R15

Fader : R15 ~ F15

Defeat : ON/OFF

Volume : 0 ~ 35

•If MODE is not pressed within 5 seconds after selecting the BASS, TREBLE, BALANCE, FADER, DEFEAT or SUBW mode, the unit automatically returns to normal mode.

* When the subwoofer mode is set to OFF, its level cannot be adjusted.

2 Turn the Rotary encoder until the desired sound is obtained in each mode.

By setting Defeat ON, previously adjusted settings of BASS and TREBLE will return to the factory defaults.

•Depending on the connected devices, some functions and display indications do not work.

Setting the Bass Control

You can change the Bass Frequency emphasis to create your own tonal preference.

1 Press MENU to select the BASS ENGINE mode, then press MODE.

BASS ENGINE SETUP RETURN (OFF) BASS ENGINE

2 Press or to select the BASS (bass Centre frequency) control mode.

BASS TREBLE

Setting the Bass Centre Frequency

3-1 Press SOURCE/POWER to select the desired bass centre frequency.

80Hz 100Hz 120Hz 60Hz 80Hz

Emphasizes the displayed bass frequency ranges.

Setting the Bass Bandwidth

3-2 Press BAND to select the desired bass bandwidth.

Changes the boosted bass bandwidth to wide or narrow. A wide setting will boost a wide range of frequencies above and below the centre frequency. A narrower setting will boost only frequencies near the centre frequency.

25-EN