Nikon WP-CP2 user manual Check for Leaks

Page 14

Check for leaks

Keep the case immersed and check whether any bubbles are emitted. After two to three seconds, take the case out of the water and check whether any droplets are inside.

Test the shooting controls

Immerse the case and operate the controls under- water for two to three minutes, checking whether any bubbles are emitted or any water enters the case.

Check for water inside the case

Take the case out of the water and check for wa- ter inside the case. If water has entered the case, check the O-ring ( 10, 17–18). If the cause of the leak can not be determined, take the case to a Nikon-authorized service representative.

After checking for leaks, dry the case thoroughly before inserting the cam- era.

Check for Leaks

7

Image 14

Contents Waterproof Case User’s ManualFor Your Safety Turn camera off immediately in the event of malfunctionDo not dive while holding Iii Temperature Table of Contents Important Use Only with Compatible Cameras Life-Long LearningPackage Contents IntroductionParts of the WP-CP2 Attaching the StrapIntroduction Using the WP-CP2 OverviewTake Pictures 13-14 Check for Leaks Check for Leaks See the camera Guide to Digital Photography Insert the CameraBatteries Insert the Camera Opening the CaseReplacing the Desiccant Insert DesiccantPerform a Final Check Close the Case Check for Leaks Again Turn the Camera On Adjust SettingsTake Pictures Use the Monitor Take PicturesDon’t Block the Shot Underwater PhotographyRemoving the Camera Clean the CaseDrying the Case Cleaning the Interior of the Case Do Not Exposure to Sunlight or HeatDo Not Use Force or Sharp Objects MaintenanceCaring for the O-ring Replacing the O-ringCleaning Grease the O-ringStorage Optional AccessoriesTechnical Notes Speciﬁcations