Nikon WP-CP2 user manual Grease the O-ring, Cleaning

Page 25

Maintenance

Grease the O-ring

If the O-ring is not properly greased, it may crack or peel, causing leaks. If the bottom of the O-ring appears dry, place a drop of O-ring grease on your index finger and spread grease on the O-ring by sliding it between your thumb and index finger, gently stretching the ring. Do not use cloth or paper, as these may leave fibers on the O-ring. Note that applying too much grease may cause foreign matter to adhere more readily to the ring, preventing the case from sealing properly.

Replace the O-ring

Making sure the O-ring and guide are free of foreign objects, place the O-ring so that it runs evenly at the same level all the way round the O- ring guide, without undue stretching and without protruding from the guide.

Check the seal

Close the case and check that the case is fully sealed. If the O-ring does not form a perfect seal, open the case and adjust the O-ring to prevent leaks.

Cleaning

Do not use detergents or volatile chemicals such as alcohol or thinner when cleaning the case. Failure to observe this precaution could result in damage to the case or O- ring.

18

Page 24 Page 26
Image 25
Page 24 Page 26
Contents User’s Manual Waterproof CaseTurn camera off immediately in the event of malfunction For Your SafetyDo not dive while holding Iii Temperature Table of Contents Life-Long Learning Important Use Only with Compatible CamerasIntroduction Package ContentsAttaching the Strap Parts of the WP-CP2Introduction Overview Using the WP-CP2Take Pictures 13-14 Check for Leaks Check for Leaks Batteries Insert the CameraSee the camera Guide to Digital Photography Opening the Case Insert the CameraPerform a Final Check Insert DesiccantReplacing the Desiccant Close the Case Check for Leaks Again Take Pictures Adjust SettingsTurn the Camera On Don’t Block the Shot Take PicturesUse the Monitor Underwater PhotographyDrying the Case Clean the CaseRemoving the Camera Do Not Exposure to Sunlight or Heat Cleaning the Interior of the CaseCaring for the O-ring MaintenanceDo Not Use Force or Sharp Objects Replacing the O-ringGrease the O-ring CleaningTechnical Notes Optional AccessoriesStorage Specifications
Top Page Image Contents