Nikon WP-CP2 user manual Check for Leaks Again

Page 19

Check for Leaks Again

Check for Leaks Again

Important!

Before use, be sure that the camera is functioning normally and that the case does not leak. Failure to check for leaks before use could result in irreparable damage to the camera.

After sealing the case, perform a ﬁnal check for leaks.

Immerse the case in water and check for leaks as described in Steps 3–6 of “Check the Case for Leaks” ( 6). Check that the desiccant stays dry and that no water enters the case. If a leak is detected, immediately remove the case from the water, dry the camera and case thoroughly, and check that the O-ring is intact and the case prop- erly sealed. If the cause of the leak can not be determined, take the case to a Nikon-authorized service representative.

12

Image 19

Contents User’s Manual Waterproof CaseTurn camera off immediately in the event of malfunction For Your SafetyDo not dive while holding Iii Temperature Table of Contents Life-Long Learning Important Use Only with Compatible CamerasIntroduction Package ContentsAttaching the Strap Parts of the WP-CP2Introduction Overview Using the WP-CP2Take Pictures 13-14 Check for Leaks Check for Leaks Batteries Insert the CameraSee the camera Guide to Digital Photography Opening the Case Insert the CameraPerform a Final Check Insert DesiccantReplacing the Desiccant Close the Case Check for Leaks Again Take Pictures Adjust SettingsTurn the Camera On Underwater Photography Take PicturesDon’t Block the Shot Use the MonitorDrying the Case Clean the CaseRemoving the Camera Do Not Exposure to Sunlight or Heat Cleaning the Interior of the CaseReplacing the O-ring MaintenanceCaring for the O-ring Do Not Use Force or Sharp ObjectsGrease the O-ring CleaningSpeciﬁcations Optional AccessoriesTechnical Notes Storage