Nikon WP-CP2 user manual Do not dive while holding

Page 3

Do not dive while holding

To prevent injury caused by the case striking the body, do not jump or dive into water while holding the WP-CP2.

Do not use below 40 m

Do not use at depths below 40 m (130´). Failure to observe this precaution could result in leakage or other malfunction.

Keep the case watertight

Do not clean the case with a high-pres- sure jet. Do not open the case where it would be exposed to dust or sand, and be sure to remove any foreign objects from the O-ring and any parts of the case that are in contact with the O- ring before closing the case. Failure to observe these precautions could result in leakage.

Do not exposure to high temperatures Do not expose the product to tem- peratures over 40 °C (104 °F). Failure to observe this precaution could cause the product to warp, resulting in leakage.

Observe caution when operating the flash

Using the flash close to your subject’s eyes could cause temporary visual impairment. Particular care should be observed if photographing infants, when the flash should be no less than one meter (39˝) from the subject.

ii

Image 3
Contents User’s Manual Waterproof CaseTurn camera off immediately in the event of malfunction For Your SafetyDo not dive while holding Iii Temperature Table of Contents Life-Long Learning Important Use Only with Compatible CamerasIntroduction Package ContentsAttaching the Strap Parts of the WP-CP2Introduction Overview Using the WP-CP2Take Pictures 13-14 Check for Leaks Check for Leaks Insert the Camera BatteriesSee the camera Guide to Digital Photography Opening the Case Insert the CameraInsert Desiccant Perform a Final CheckReplacing the Desiccant Close the Case Check for Leaks Again Adjust Settings Take PicturesTurn the Camera On Underwater Photography Take PicturesDon’t Block the Shot Use the MonitorClean the Case Drying the CaseRemoving the Camera Do Not Exposure to Sunlight or Heat Cleaning the Interior of the CaseReplacing the O-ring MaintenanceCaring for the O-ring Do Not Use Force or Sharp ObjectsGrease the O-ring CleaningSpecifications Optional AccessoriesTechnical Notes Storage