Nikon WP-CP2 user manual Close the Case

Page 18

5. Close the Case

Close the case

After making sure that the O-ring is in place, slowly close the case, being careful not to pinch your ﬁngers in the gap.

	Latch the case
	With front and rear halves of the case lightly
	touching but the case not fully closed (), ﬂip the

buckle onto the front half of the case ().

Press the case closed until the latch clicks shut. Check that the case is properly sealed, that the O-ring is in place, and that no foreign objects are caught in the seal.

Insert the Camera

11

Image 18

Contents Waterproof Case User’s ManualFor Your Safety Turn camera off immediately in the event of malfunctionDo not dive while holding Iii Temperature Table of Contents Important Use Only with Compatible Cameras Life-Long LearningPackage Contents IntroductionParts of the WP-CP2 Attaching the StrapIntroduction Using the WP-CP2 OverviewTake Pictures 13-14 Check for Leaks Check for Leaks Insert the Camera BatteriesSee the camera Guide to Digital Photography Insert the Camera Opening the CaseInsert Desiccant Perform a Final CheckReplacing the Desiccant Close the Case Check for Leaks Again Adjust Settings Take PicturesTurn the Camera On Use the Monitor Take PicturesDon’t Block the Shot Underwater PhotographyClean the Case Drying the CaseRemoving the Camera Cleaning the Interior of the Case Do Not Exposure to Sunlight or HeatDo Not Use Force or Sharp Objects MaintenanceCaring for the O-ring Replacing the O-ringCleaning Grease the O-ringStorage Optional AccessoriesTechnical Notes Speciﬁcations