Yamaha RX-V2500 Speaker impedance setting, Turning on the power, SP IMP.-8 MIN, Connections

Speaker impedance setting

Be sure this unit is in the standby mode.

1On the front panel, while holding down

STRAIGHT/EFFECT, press STANDBY/ON.

“SP IMP.–8ΩMIN” appears on the front panel display.

STRAIGHTSTANDBY

/ON

EFFECT

SP IMP.-8 MIN

2Press STRAIGHT/EFFECT to select the impedance of your speakers.

You can select either 6 ohms or 8 ohms.

3Press STANDBY/ON to exit the setting.

This unit will be set to the standby mode.

Note

Speaker impedance setting function is located in the Advanced menu (see page 84).

CAUTION

If you are using 6 ohm speakers, set the impedance to 6 ohms before turning on the power.

CONNECTIONS

Turning on the power

When all connections are complete, turn on the power of this unit.

	1
										VOLUME
			INPUT
			PURE DIRECT
	STANDBY
	/ON
				PRESET/	PRESET		TUNING	ZONE ON/OFF
			A/B/C/D/E	TUNING	/TUNING FM/AM	MEMORY	MODE	MAIN	ZONE 2	PROGRAM
SPEAKERS		MULTI CH	INPUT MODE			MAN'L/AUTO FM	AUTO/MAN'L MONO		TONE CONTROL		PREPARATION
A	B	INPUT	POWER	POWER	STANDBY					STRAIGHT
						POWER
					SILENT CINEMA
				YPAO						EFFECT
			REC OUT /ZONE 2
								VIDEO AUX
									(U.S.A. model)
						SYSTEM		1
			TV	AV

A	B	INPUT MODE	SLEEP
PHONO	TUNER	CD	MULTI CH IN
V-AUX	CBL/SAT	MD/TAPE	CD-R
DTV	VCR 1	DVR/VCR2	DVD

SELECT

AMP

+ + +

1Press STANDBY/ON (SYSTEM POWER on the remote controls) to turn on the power of this unit.

SYSTEM

POWER

STANDBY

/ONor

Front panel Remote control

2Turn on the video monitor connected to this unit.

Note

Press STANDBY/ON again (STANDBY on the remote control) to enter the standby mode.

English

25