Yamaha RX-V2500 Connecting the antennas, Connecting the AM loop antenna, 1Open the cover of the

Connecting the antennas

Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals.

Indoor FM antenna	AM loop antenna
(included)	(included)

TUNER

FM ANT

75Ω

UNBAL.

GND

AM

ANT

COMPONENT VIDEO

Y PB PR

DVD

DTV

CBL/

SAT

MONITOR

OUT

Ground (GND terminal)

For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.

■Connecting the AM loop antenna

1Set up the AM loop antenna, then connect it to the terminals on this unit.

2Press and hold the tab to insert the AM loop antenna lead wires into the AM ANT and GND terminals.

CONNECTIONS

3Orient the AM loop antenna for the best reception.

Notes

•The AM loop antenna should be placed away from this unit.

•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.

•A property installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about outdoor antennas.

■75-ohm/300-ohm antenna adapter (U.K. model only)

1Open the cover of the

included 75-ohm/300-ohm antenna adapter.

2Cut the external sleeve

of the 75-ohm coaxial	11 (7/16)	Unit:
	8 (5/16)
		mm (in)
cable and prepare it for 6 (1/14)
connection.
3 Cut the lead wire and
remove it.		Lead wire

4 Insert the cable
wire into the slot,	Clamp	Clamp
and clamp it with
pliers.
	Insert the wire
	into the slot

5 Snap the cover into place.

PREPARATION

English

23