Yamaha RX-V2500 Manual setup: Option, Display Display, 4Select Option then press h, Dimmer Dimmer

Manual setup: Option

This menu adjusts the optional system settings.

1Set AMP/SOURCE/TV to AMP.

AMP

SOURCE

TV

2Press TOP on the remote control.

3Select Manual Setup, then press h.

4Select Option then press h.

Sound	Display
Basic	Multi Zone
Option	Surr.Initialize
	Input Mode
	Memory Guard

5Select the desired parameters, then press h to access and adjust.

6When finished adjusting parameters, press

ENTER.

■Display (Display)

Use this feature to adjust the GUI and front panel displays.

Manual Setup > Option > Display >

	Dimmer
	Video Conv.
Display	Short Message
Multi Zone	Position
Surr.Initialize	Wall Paper

Dimmer (Dimmer)

Use to adjust the brightness of the front panel display. Choices: –4 to 0

SYSTEM OPTIONS

Video Conv. (Video conversion)

Use this feature to turn on/off conversion of composite (VIDEO) signals to both S-video and component signals. This allows you to output converted video signals from the S VIDEO or COMPONENT VIDEO jacks when no S-video or component signals are input. This feature also converts S-video signals to component signals when no component signals are input.

Choices: Off, On

•Select “Off” not to convert any signals.

•Select “On” to convert composite signals to S-video and component signals, and to convert S-video signals to component signals.

y

When using the THX system, we recommend setting Video Conv. to “Off”.

Notes

•Converted video signals are only output to the MONITOR OUT jacks. When recording you must make the same type of video connections (composite or S-video) between each component.

•When converting composite video or S-video signals from a VCR to component video signals, the picture quality may suffer depending on your VCR.

Short Message (Short message)

Use this feature to turn on/off the short message display. Choices: Off, On

•Select “Off” to turn off the short message display.

•Select “On” to turn on the short message display.

Notes

•The short message display may not display properly depending on the type of input signal and video monitor used.

•If Video Conv. is set to “Off”, the short message display is not displayed even if “On” is selected.

Position (Position)

Use to adjust the vertical and horizontal position of the GUI display.

Choices: –5 (downward/left) to +5 (upward/right)

•Press k to raise the position of the GUI display.

•Press n to lower the position of the GUI display.

•Press h to shift the position of the GUI display to the right.

•Press lto shift the position of the GUI display to the left.

Wall Paper (Wallpaper)

Use this feature to select the background when no image is input from an external source. If you do not want to display the background, select None.

Choices: None, Yes, Gray Back

Note

If Video Conv. is set to “Off”, no background is displayed even if “Yes” is selected.

y

This menu item is also available in the front panel display system options menu (see page 85).

OPERATION ADVANCED

English

65