Yamaha RX-V2500 Input Select, I/O Assignment Input / output assignment, Volume Trim Volume trim

SYSTEM OPTIONS

Input Select

Use this feature to reassign digital input/outputs, select the input signal, rename the inputs, or adjust the level of the signal input to each jack.

1Set AMP/SOURCE/TV to AMP.

AMP

SOURCE

TV

2Press TOP on the remote control.

3Select Input Select, then press h.

	CD-R
Stereo/Surround	MD/TAPE
Input Select	DVD
Manual Setup	DTV
Auto Setup	CBL/SAT

4Select the desired input (CD, DVD, etc.), then press h to access and adjust.

■I/O Assignment

(Input / output assignment)

You can assign the digital audio input/output and component video jacks to other components if this unit’s initial settings do not correspond to your needs. Change the following parameters to reassign the jacks and effectively connect more components.

Once the jacks are reassigned, you can select the corresponding component using INPUT SELECTOR on the front panel or the input selector buttons on the remote control.

Input Select > input source (DVD, etc.) >

I/O Assignment >

Example 1:

To assign the COAXIAL 7 (CD) jack to the DVD input.

1)Select Input Select, then select DVD.

2)Select I/O Assignment > Coaxial Input, then select 7 CD.

Example 2:

To clear a jack assignment.

1)Select Input Select, then select the input source (DVD, etc.).

2)Select I/O Assignment, then select the jack assignment (Optical Output, Optical Input, Coaxial Input or Component Video).

3)Select NONE, then press ENTER to clear the assignment.

I/O Assignment	Optical Output
Volume Trim	Optical Input
Rename	Coaxial Input

y

This menu item is also available in the front panel display system options menu (see page 85).

Notes

•You cannot select a specific item more than once for the same type of jack.

•When you connect a component to both the COAXIAL and OPTICAL jacks, priority is given to the input signals from the COAXIAL jack.

■Volume Trim (Volume trim)

Use this feature to adjust the level of the signal input to each jack. This is useful if you want to balance the level of each input source to avoid sudden changes in volume when switching between input sources.

Input Select > input source (DVD, etc.) > Volume Trim > Control range: –6.0 dB to +6.0 dB

y

This menu item is also available in the front panel display system options menu (see page 85).

56