Yamaha RX-V2500 Troubleshooting for the auto setup procedure, Before auto setup, Error message

AUTO SETUP

■Troubleshooting for the auto setup procedure

Before auto setup

Error message	Cause	Remedy
Connect MIC!	Optimizer microphone is not connected.	• Connect the supplied optimizer microphone to the
		OPTIMIZER MIC jack on the front panel.
Unplug Phones!	Headphones are connected.	• Unplug the headphones.
No Setup Menu!	No setup menu items have been selected.	• Select at least one setup menu item.
Memory Guard!	This setting is protected.	• Remove the protection setting for auto setup (see
		page 67).

During auto setup

Press l / h to display detailed information for individual errors. Select Retry to try the auto setup procedure again.

Error message	Cause	Remedy
E01:No Front SP	Front L/R channel signal(s) is (are) not	• Select the front speakers with SPEAKERS A or B.
	detected.	• Check the front L/R speaker connections.
E02:No Surr. SP	Only one surround channel signal is detected.	• Check the surround speaker connections.
E03:No Pres. SP	Only one presence channel signal is detected.	• Check the presence speaker connections.
E04:SBR ->SBL	Only the surround back right channel signal is	• Connect the surround back speaker to the LEFT
	detected.	SURROUND BACK SPEAKERS terminal if you
		only have one surround back speaker.
E05:Noisy	Background noise is too loud.	• Try auto setup in a quiet environment.
		• Turn off noisy electric equipment like air
		conditioners, or move them away from this unit.
E06:Check Surr.	Surround back speaker(s) is (are) connected,	• Connect surround speakers when using (a) surround
	though surround L/R speakers are not.	back speaker(s).
E07:No MIC	The optimizer microphone was unplugged	• Connect the supplied optimizer microphone to the
	during the auto setup procedure.	OPTIMIZER MIC jack on the front panel.
E08:No Signal	The optimizer microphone does not detect test	• Check the microphone setting.
	tones.	• Check the speaker connections and placement.
E09:User Cancel	The auto setup procedure was cancelled	• Perform the auto setup procedure again.
	because a setting that affects auto setup was
	changed during the procedure.
E10:Internal Err	An internal error occurred.	• Restart this unit, then try the auto setup procedure
		again.

30