Yamaha RX-V2500 Connecting the power cable, Connecting the AC power cable, Ac Outlets Switched

CONNECTIONS

Connecting the power cable

AC OUTLETS

(U.S.A. model)

VOLTAGE SELECTOR

VOLTAGE

SELECTOR

2

(General model)

■Connecting the AC power cable

Plug the power cable into the AC inlet after all other connections are complete, then plug the power cable to an AC wall outlet.

CAUTION

Do not use other AC power cables. Use the one provided. Use of other power cables may result in fire hazard or electrical shock.

■AC OUTLET(S) (SWITCHED)

U.K. and Australia models	..................................... 1 outlet
Korea model	None
Other models	2 outlets

Use these outlets to connect the power cables from your other components to this unit. Power to the AC OUTLET(S) is controlled by this unit’s STANDBY/ON (or SYSTEM POWER and STANDBY). These outlets will supply power to any connected component whenever this unit is turned on. The maximum power (total power consumption of components) that can be connected to the AC OUTLET(S) is:

Asia and General models	.......................................... 50 W
Other models	100 W

■VOLTAGE SELECTOR

(Asia and General models only)

The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local main voltage BEFORE plugging into the AC main supply. Voltages are:

General model	AC 110/120/220/230–240 V,	50/60 Hz
Asia model	AC 220/230–240V,	50/60 Hz

■Memory back-up

The memory back-up circuit prevents the stored data from being lost even if this unit is in the standby mode. However if the power cable is disconnected from the AC wall outlet, or the power supply is cut for more than one week, the stored data will be lost.

24