Star Trac 620-7920 manual Step

Page 12

Step 25.

Install left and right handrail grommets. Slide the grommet down the rail and snap it in place over the bed rails covers. Push down and ro- tate the grommet slightly to seat the tabs into the plastic covers.

Note: Make sure the grommet is tightly secured in place.

Step 27.

Secure the power cable to the frame with the tie -strap and cut excess strap.

Caution: Make sure not to damage the power cord.

13

Step 26.

Insert the power cord through the tie wrap loop below motor compartment and connect it to the power receptacle.

Note: Don’t turn on the power switch yet.

Step 28.

Position the treadmill in its place. If leveling the treadmill is necessary, loosen the lock nuts of the leveling feet, rotate the feet until the tread- mill is stabilized, then re-tighten the lock nuts.

620-7920 Rev A

Image 12
Contents Work Instructions General Unpacking Instructions Verify components in box two 1.Neck cover Verify the following tools are included in the hardware kit Installation Instructions Step For E-TRxe model only Step Step Step Step LED Display Console Installation Instructions Step Step YOU have NOW Completed the E-TRx Treadmill Installation Once powered up, all features of the unit function properly This page Intentionally Left Blank Embedded Display Console Installation Instructions Coax cable Contact heart rate Hot Bar Stop Interface YOU have NOW Completed the Embedded Display Installation Rev a This page Intentionally Left Blank IPod Center Console Installation Instructions Screw Step Install the new iPod center console YOU have NOW Completed the iPod Center Console Installation Rev a This page Intentionally Left Blank MYE Entertainment Center Console Installation Instructions Screw Step Step YOU have NOW Completed the MYE Center Console Installation Rev a This page Intentionally Left Blank Personal Viewing Screen PVS Installation Instructions From PVS From Neck TR Headphone Hot Bar Headphone Jack assembly Step DC power jack Step Rev a Star Trac Star Trac Fitnesstm Settings and Testing Maintenance Mode Oper Hours Motor Calibration Elevation Calibration Troubleshooting