NordicTrack NETL15520 manual Assembly, Extension Legs 88 remain in the Uprights, Handrail Bolts

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own phillips screwdriver, adjustable spanner and wire cutters .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the treadmill or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt or foot pads, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

WARNING: Do not plug in the power	1
cord until the treadmill is completely assembled.
		110
1. With the help of a second person, carefully raise the
Uprights (110) to the position shown.
Refer to the inset drawing. Insert one of the Extension			110
Legs (88) into the treadmill as shown. Make sure that the
Thick Base Pad (90) is on the bottom. (Note: It may be
helpful to tip the Uprights [110] forward as you insert the			88
Extension Leg.) Insert the other Extension Leg (not
shown) in the same way.			90
2. With the help of a second person, carefully tip the	2
Uprights (110) down as shown. Make sure that the
Extension Legs (88) remain in the Uprights.
		90
Attach each Extension Leg (88) with two Base Screws		90
(86) and a Base Pad (90) as shown.			90
With the help of a second person, carefully tip the		110
Uprights (110) back to the vertical position.	110
		88	86
Note: One replacement Base Pad (90) may be included.
	90		90
		86
	90	88
3. Refer to drawing 3a. Whilst another person holds the	3a
Handrails (89), thread Handrail Bolts (111) two to three
turns into the two holes in each Handrail. Then, remove		89
the Handrail Bolts.
Refer to drawing 3b. Pinch the tabs on the Grounding
Bracket (115) so that the tabs will fit into the indicated		111
hole in the left Upright (110). Then, insert the Grounding
Bracket into the hole as far as possible.
	3b	115
Note: It may be helpful to set the Handrails (89) on the		110
Uprights (110) and loosely thread a Handrail Bolt (111)		111
into the left Upright and the left Handrail. Tip the
Handrails, if necessary, to thread in the Handrail Bolt.
Have another person support the Handrails as you com-
plete the remaining steps.

6