Operation and Adjustment

•The CR2032 battery may need to be replaced. Follow the steps below to replace the battery.

Next, remove the old battery from the sensor unit. Insert a new CR

Locate the battery cover on the back of the sensor unit. Insert a coin into the slot in the cover and turn the cover counterclockwise to the “open” position. Remove the cover.

Battery Cover

2032 battery, making sure that the writing is on top. In addition, make sure that the rubber gas- ket is in place in the sensor unit. Replace the battery cover and turn it to the closed position.

CR2032 Battery

Rubber Gasket

THE PERFORMANT LUBETM WALKING BELT

Your treadmill features a walking belt coated with PERFORMANT LUBETM, a high-performance lubricant. IMPOR-

TANT: Never apply silicone spray or other substances to the walking belt or the walking platform. Such substances will deteriorate the walking belt and cause excessive wear.

HOW TO PLUG IN THE POWER CORD

This product must be earthed. If it should malfunction or break down, earthing provides a path of least resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-earthing conductor and an earth- ing plug.

Two power cords are included. Select the one that will fit your outlet. Refer to drawing 1, and plug the indicated end of the power cord into the socket on the treadmill. Next, lift the indi- cated tab on the ferrite box and clamp the ferrite box around the power cord. The ferrite box should not be allowed to slide along the power cord. Fasten the included plastic tie just be- hind the ferrite box and cut off the excess plastic tie. Refer to drawing 2. Plug the power cord into an appropriate outlet that is properly installed and earthed in accordance with all local codes and ordinances. Note: In Italy, an adaptor (not included) must be used between the power cord and the outlet. Important: The treadmill is not compatible with GFCI-equipped outlets.

If the power cord is damaged, it must be replaced with a manufac- turer-recommended power cord.

Socket on treadmill

Ferrite Box

Plastic

Tie

Tab

Outlet

DANGER: Improper connection of the equipment-earthing conductor can result in an in- creased risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the product is properly earthed. Do not mod- ify the plug provided with the product—if it will not fit the outlet, have a proper outlet installed by a qualified electrician.