NordicTrack NETL15520 manual Tighten the Bolts yet

4. Pull the Upright Wire Harness (101) up through a	4			A
Handrail Spacer (114). Place the Handrail Spacer on the
right Upright (110) as shown, with the cutout turned to-		76		Cutout
ward the treadmill (see inset drawing A).				114
Connect the Upright Wire Harness (101) to the wires ex-			89
tending from the Console Base (76). Insert the connec-						110
tors and the Upright Wire Harness into the hole in the		101	110	B	101
Console Base (see inset drawing B).
Set the Handrail (89) on the right Handrail Spacer (114),
being careful not to pinch the Upright Wire Harness (101).
		114
						76
5. Insert two Handrail Bolts (111) with Handrail Washers	5					89
(112) and Handrail Bushings (113) into the right Upright
						114
(110) and the right Handrail Spacer (114). Turn the
						115
Handrail Bushings so they fit against the Upright with the			89
thick sides of the Bushings toward the centre of the tread-			116
mill (refer to the inset drawing). Lift the right Handrail (89)
						111
slightly and align the Bolts with the holes in the Handrail.			110
Loosely thread the Bolts into the Handrail. Do not
	114		113
tighten the Bolts yet.						Thick
				112		Side
Refer to the inset drawing. Remove the Handrail Bolt
(111) used in step 4. Place the other Handrail Spacer
(114) on the left Upright (110), with the cutout toward the		113
treadmill. Reach inside the left Upright and spread the
		112			111
tabs on the Grounding Bracket (115) to allow a Bolt to
pass through the Grounding Bracket. Attach the left
Handrail (89) as described above. Make sure that the
Handrail Bushings (113) are turned properly and that the
Bolt goes through the Grounding Bracket. Tighten all
four Handrail Bolts. Press an Upright Endcap (116) into
each Upright.
6. Make sure that the Lock Knob Sleeve (106) is pressed	6
into the left Upright (110).
Make sure that the Lock Pin Collar (105) and the Spring
(104) are on the Lock Pin (102). Insert the Lock Pin into			110
the Lock Knob Sleeve (106) and the left Upright (110).
Next, press the Lock Knob Spacer (107) onto the left
Upright. Tighten the Lock Knob (108) onto the Lock Pin.
	108		106	104
		107
					105
						102

7.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 28). To protect the floor or carpet from damage, place a mat under the treadmill.

7