PROBLEM
4.The walking belt is off-center or slips when walked on
SOLUTION |
| |
a, | If the walking belt has shifted to the | a |
left, first remove the key and UNPLUG
THE POWER CORD. Using the allen wrench, turn the left rear roller adjustment bolt clockwise, and the right bolt counter- clockwise, 1/4 of a turn each. Be careful not to ovartighten the walking belt. Plug in the power cord, insert the key and run the
treadmill for a few minutes. Repeat until the walking belt is centered.
b. If the walking belt has shifted to the right, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left roar roller adjustment bolt counterclockwise, and the fight bolt
clockwise, 1/4 of a turn each. Be careful
not to overtighten the walking belt. Plug in the power cord, insert the key and run the
treadmill for a few minutes. Repeat until the walking belt is centered.
c. If the walking belt slips when walked
C
on, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller adjustment bolts clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you shouid be able to lift the edges of the walking belt 3 to 4 inches off the walking
platform. Be careful to keep the walking belt centered. Plug in the power cord, in- sert the key and run t_e treadmill for a few minutes. Repeat until the walking belt is propedy tightened.
5. The displays of the | a. Remove the key from the console and UN- |
|
| |
console do not func- | PLUG THE POWER CORD. Next, remove | |||
tion properly | the screws from the hood and carefully re- | |||
|
| |||
| move the hood. Locate the Reed Switch |
|
| |
| (26) and the Magnet (85) on the left side of |
|
| |
| the Pulley (28). Turn the Pulley until the |
|
| |
| Magnet is aligned with the Reed Switch. |
|
Make sure that the gap between the | v,ew | |
Magnet and the Reed Switch is about | ||
|
1/8". If necessary, loosen the Reed Switch
Screw (2) and move the Reed Switch slightly. Retighten the Screw.
23