Assembly

The parts are packed in two separate packages. Check that all the following parts are in the packages:

1.H-frame

2.Vertical frame

3.Shocks (2)

4.Handlebars (3)

5.Meter

6.Assembly kit (contents marked with in the spare part list): keep the assembly tools, as you may need them e.g. for adjusting the equipment.

If you notice that a part is missing, contact the dealer and give the model (S90), serial number and spare part number from the list at the back of the manual. The package includes a silicate bag for absorbing moisture during storage and transportation. We recommend two persons for the assembly. Assemble the device as follows (left, right, front and back are as seen from the exercising position):

H-FRAME AND VERTICAL FRAME

Place the plastic insulation plate between the vertical and the H-frame. Insert 4 M8x55 mm button head bolts up through the bottom of the H-frame. Place the vertical frame over the bolts. Add a washer to each bolt and secure each using the 5 mm hexagon key and the 13 mm open-end wrench and the M8 lock nut provided. Lift the climber back into the upright position.

O W N E R ’ S M A N U A L • S 9 0 GB

SHOCK ABSORBERS

Attach the end of the shock absorber that contains the resistance adjustment mechanism to the left side of the vertical frame. Slide the end of the shock absorber and a suitable spacer over the shock mount shaft on the left side of the vertical frame. Secure with the M8x40 mm button head bolt and lock washer using the 5 mm hexagon key provided. Attach the right shock absorber in the same manner.

Slide a metal spacer inside the ring on the bottom of the shock absorber. Fasten the ring to the bracket on the left foot pedal with the M8x40

mmbutton head bolt and with the M8 lock nut. Use the 13 mm open-end wrench to hold the nut while you tighten the bolt with the 5 mm hexagon key provided. NOTE! Be careful not to overtighten the bolt as this may crack the plastic bushing. Attach the right shock absorber to the right foot pedal in the same manner.

HANDLEBARS