NordicTrack NTEL7906.0 HOW to USE a Custom Program, Using it. To change the resistance level for

HOW TO USE A CUSTOM PROGRAM

1Turn on the console. See step 1 on page 13.

2Select a custom program.

To select a custom program, press the Custom Programs button repeatedly until the words CUS- TOM 1 or CUSTOM 2 appear in the display.

When you select a custom program, the name of the program, the program time, and the maximum pace and resistance level will appear in the dis- play for a few seconds. A profile of the resistance levels of the program will then appear in the dis- play.

Profile

As you exercise, you will be prompted to

keep your pedaling

pace near the target pace setting for the

current segment.

When an upward-pointing arrow or the prompt SPEED UP appears next to the pace information in the display (see step 4 on page 16), increase your pace. When a downward-pointing arrow or the prompt SLOW DOWN appears, decrease your pace. When no arrow or prompt appears, maintain your current pace. Important: The tar- get pace settings are intended only to provide motivation. Make sure to pedal at a pace that is comfortable for you.

If the resistance level for the current segment is too high or too low, you can manually override the setting by pressing the OneTouch Resistance buttons. However, when the current segment ends, the pedals will automatically adjust to the resistance level for the next segment.

If you stop pedaling for several seconds, a series of tones will sound and the program will pause. To restart the program, simply resume pedaling. The program will continue until the last segment of the profile flashes and the last segment of the pro- gram ends.

3	Begin pedaling to start the program.		Change the program if desired.
		4
	Each custom program is divided into 30 one-
	minute segments. One resistance level and one		If desired, you can change the program while
	target pace setting are programmed for each seg-		using it. To change the resistance level for the
	ment. Note: The same resistance level and/or tar-		current segment, simply press the OneTouch
	get pace setting may be programmed for two or		Resistance buttons. At the end of the current seg-
	more consecutive segments.		ment, the new resistance level will be stored in
			memory. To change the target pace for the cur-
	During the program, the program profile will show		rent segment, simply change your pedaling
	your progress. The flashing segment of the profile		pace. At the end of the current segment, your
	represents the current segment of the program.		pace will be stored in memory. You can continue
	The height of the flashing segment indicates the		exercising and changing the program for up to
	resistance level for the current segment. At the		thirty minutes.
	end of each segment of the program, a series of
	tones will sound and the next segment of the pro-
	file will begin to flash. If a different resistance
	level is programmed for the next segment, the
	resistance level will appear in the display for a
	few seconds to alert you. The resistance of the
	pedals will then change.

17