ParaBody 425 manual FROMPAGE12, IMPORTANT!!! Tighten the NUT

Page 12

(CONTINUEDFROMPAGE12..)

C.SECURELYassemble the WEIGHT STACK SHAFT (104) fo the HEAD PLATE (105) as shown on drawing, using one 5/B X 1 IN. BUTTON HEAD CAP SCREW(78) and one 5/8 IN. BLACK LOCK WASHER(77).

D.Shop two WEIGHT PLATE BUSHINGS(107) each, into fifteen WEIGHT PLATES (105) as shown.

ASSEMBLINGA 200 LB. STACK AT THIS TIME, SNAP TWOWEIGHT PLATE BUSHINGS (107) EACH INTO THE REMAINING FIVE WEIGHT PLATES (105)).

E.USING EXTREMECAREslide all fifteen (or twenty) WEIGHTPLATES(105) down over the OUIDE

RODS (27) onto the WEIGHT STACK CUSHIONS (59) as shown on drawing. (MAKE SURE THAT KEY HOLES OF THE WEIGHT PLATES ARE ALL FACING THE SAME WAY)

F.Slide the HEAD PLATE ASSEMBLYdown over the GUIDE RODS (27) onto the WEIGHT STACK as shown on drawing.

G.Swing the OUIDE RODS (27) under the TOP BOOM(5) as shown on drawing, and hold in place with NYLONBOLTS (44).

G.Attach the WEIGHT STACK LABELS (101) to the WEIGHTSTACK SELECTORPIN (58) into the first

WEIGHTSTACK as shown on drawing. Also insert the WEIGHTPLATE (105) of the WEIGHTSTACK.

Step 1 0

SECURELYassemble one .5/8 IN. SPRING PIN ASSEMBLY(49) to the SPRING PIN HOUSING, of the FRONTUPRIGHT (22) us shown.

(!!! IMPORTANT!!! TIGHTEN THE NUT OF

THE SPRING PIN ASSEMBLYSECURELY)

B.Attach one THUMBSCREW(46) fo the FRONT UPRIGHT (22) as shown on drawing.

Assemble two ROLLER PADS (50) fo the FRONT UPRIGHT (22) using one ROLLER PAD

SHAFT (35), and two 9/16 MUSHROOM

CAPS(52).

1/2

i

1/2 I

1/2 I

1/2 I

1/2

I

I

, I I

I I 1 I I ! I2

3

 

4

5

6

I

 

 

 

 

13

Image 12
Contents SeriousSteel Ii/i/I 58 6214401 PIN Weightstackselector CAP Joint CONNECTOR3/8Label WEIGHTSTACK1-25 WeightplateAssemblyInstructions StepI I Sep Step Sfep Step Step I12 I I12 ~epSiep FROMPAGE12 IMPORTANT!!! Tighten the NUT~ep1 PUSH/PULL Cable Press Adjustmenttube Sfep 1Sep 1 Sfep 1 ~ Page IMPORTANT!! Tighten the NUT Spring PIN Assemblysecurely Assemblysecurely Important !!! Tighten the NUT of the SpringPIN Assemblysecurely Press Back Support to Rotate FreelyCable Guide On Next LAT CA~LE Cable Form a Loop in the Center of the Cable III Extension LAT 3CK ThreadedshaftTOPBO0 M---~ Sep B X 1 IN. Button Head CAP SCREWS78