ParaBody 425 manual Sep 1

@'~"-/2 X 3-1/2"

/p"~ H/-'-P ~'L"~

//

IMPORTANT

DONOTOVERTIGHTEN1 IN. NUTS,

S]ep 1 5

A.Insert two 3/4 IN. FLANGEBEARINGS(9.3) into the PRESSARM (2) as shown on the drawing.

B.Hold the PRESS ARM(2) between the REAR and MIDDLE UPRIGHTSas shown in on drawling, and slide the 10-1/4 IN. AXLE (102) through the MIDDLE UPRIGHT, the PRESS ARM, and through the COLLAR on the REAR UPRIGHT. To SECUREthe AXLE (102) in place, insert two 5/16 X 3/8 IN. SET SCREWS(82),

the COLLARSon the UPRIGHTSand tighten if down onto the AXLE (102).

C.Insert two 1/2 IN. FLANGE BEARINGS(95) into the PRESSARM (2) as shown on drawing.

D.Assemble the RECEIVING TUBE (12) fo the PRESS ARM.(2) as shown on drawing, using one 1/2 5-1/2 IN. BOLT (68), two 1/2 IN. WASHERS(65), and one 1/2 IN. LOCK NUT (90). (TIGHTEN CONNECTIONENOUGHTO REMOVETHE PLAY, YET ALLOWING THE PRESS ARM (2) TO ROTATE FREELY)

E.Assemble lhe PUSH/PULL CABLE fo the SPRING PIN HOUSING end fo the L-BRACKET on RECEIVINGTUBE (12) es shown, using ~he following steps:

*Thread the first	1/4-28 IN.	NUT (81) to	the bottom of the threaded	end	of the CABLE. Allow the
other 1/4-28 IN.	NUT (81)	fo hang loose	on the exposed CABLE until	the	SPRING PIN ASSEMBLY
attached.

*Securely assemble the SPRING PIN ASSEMBLYfo the SPRING PIN BARREL. (~ IMPORTANT HI TIGHTEN THE NUT OF THE SPRING PIN ASSEMBLYSECURELY)

*Swing the PRESSARM (2) up until the SPRING PIN of the PUSH/PULL CABLE engages in one the adjustment holes.

~Thread the second 1/4-28 IN. NUT (81) onto the threaded end of ]he CABLE, and cinch the fwo 1/4-28 IN. NUTS (81).around the fla].

~Use the extra thread on	Che end	of	]he CABLE to adjust	out	slack.	(	~H DO NOT ADJUST OUT TO
FAR ~H ALWAYSALLOW SPRING PIN ASSEMBLYTO FULLY ENGAGE)
~AHach one ADHESIVE CLIP	(88) fo	the	RECEIVING TUBE (12)	and	snap	~he	CABLE

0	I ,I	1	I	2	I	~	I I I , I I I I	I I
I		I I I	,	I I !	, I	I i

17