ParaBody 425 manual Important !!! Tighten the NUT of the Spring, Assemblysecurely

Page 20

~3/8X 3"

L

Step 21

A.Pre-assemble the PRESSBACK SUPPORT(5) using the following steps:

*Att(]ch eight PARAOLIDESTRIPS (50) to the PRESSBACKSUPPORT(5) using the following steps: *Thoroughly clean all surfaces where the PARAGLIDE~;TRIPS (50) ore "~o be attached.

*Remove the PARAGLIDESTRIPS from the paper backing and firmly apply them fo the surfaces.

*SECURELYassemble one 5/8 IN. SPRING PIN ASSEMBLY(49) to the SPRING PIN HOUSING,

the PRESS BACK SUPPORT(5)

as shown. (!!!

IMPORTANT !!! TIGHTEN THE NUT OF THE SPRING

ASSEMBLYSECURELY.)

 

 

 

 

 

 

*SECURELY assemble

two

5 IN.

WHEELS(54)

~o

the

PRESS BACK SUPPORT(S) as

shown on drawing,

using two 5/8

X 2-5/4

IN.

BOLTS (75),

two

5/8

IN. WASHERS(69), and two

5/8 X 1/4

SPACERS(96).

(IF

THE WHEELSDO NOT ROTATE FREELY AFTER THE BOLTS ARE TIGHT,

REMOVEWASHERS.)

B.SECURELYassemble the SEAT PAD (.51) to the ADJUSTABLEPRESSSEAT (14) us shown, using 3/8 X 2-3/4IN. BOLTS (75), two 3/8 IN. LOCK WASHERS(70), and ~wo 3/8 IN. WASHERS(69).

C. Pull buck the SPRING PIN (49) on the PRESSBACK SUPPORT(3) and slide flqe ADJUSTABLEPRESS SEAT (14) in~o the RECEIVING WELL. Engage the SPRING PIN (49) into one of the adiusfmenf holes. Secure the ADJUSTABLEPRESSSEAT (14) in place with one THUMBSCREW(46).

D.SECURELYassemble the BACK PAD (32) to the PRESSBACK SUPPORT(12), using

3/B X ..5

IN. BOLTS (73),

two

3/8 IN.

LOCK WASHERS(70),

und two

3/8 IN.

WASHERS

I

i

1/2 I

1/2

I

in I

'1

1/2

I

0

1

} i

I.

I,,,I,,,

 

 

I_~

6

I=

 

 

 

5

 

21

Image 20
Contents SeriousSteel Ii/i/I 58 6214401 PIN Weightstackselector CAP Joint CONNECTOR3/8Label WEIGHTSTACK1-25 WeightplateI I AssemblyInstructionsStep Sep Step Sfep Step Step I12 I I12 ~epSiep FROMPAGE12 IMPORTANT!!! Tighten the NUT~ep1 PUSH/PULL Cable Press Adjustmenttube Sfep 1Sep 1 Sfep 1 ~ Page IMPORTANT!! Tighten the NUT Spring PIN Assemblysecurely Assemblysecurely Important !!! Tighten the NUT of the SpringPIN Assemblysecurely Press Back Support to Rotate FreelyCable Guide On Next LAT CA~LE Cable Form a Loop in the Center of the Cable III Extension LAT 3CK ThreadedshaftTOPBO0 M---~ Sep B X 1 IN. Button Head CAP SCREWS78