ParaBody 425 manual On Next

S~ep 1

To assemble the D-RING CABLE(115), follow the cable routin# as shown, and use the follow!ng steps:

*SECURELYassemble the D-RING CABLE (115) to the WEIGHT STACK SHAFT (104) of the HEADPLATE (10.5) as shown.

*Route the CABLE (115) up cmd over the two PULLEYSin the LAT BOOM(5) aboYe the WEIGHT STACK. (REMOVE PULLEYS FOR EASE OF INSTALLATION)

*LOOSELY assemble the D-RING (28) to the D-RING CABLE (115) shown on drawing, using one 1/4 IN. WASHER(80), and two

1/4-28 IN. NUTS (81). (LOCATE 1/4-28 NUTS (81) HALF UP ON THE THREADS OF THE D-RING CABLE (115).

NOT TIGHTEN NUTS AT THIS TIME)

*SECURELYTighten the two PULLEY connections from the PREVIOUSSTEP.

*NOTE; REMOVEBOLTSFOR CABLEINSTALLATION!

Step 2

A. To assemble the LAT CABLE (112),		follow the	cable routing drawing, and use the
following	steps:
~Attach	one SNAPLINK (55) to the	bull end of	the LAT CABLE(112).

~'Remove the two bolts in the FRONTUPRIGHT (22) and TOP BOOM(5) connection.

~Route the LAT CABLE (112) as shown on drawing. (REMOVE PULLEYS FOR EASE INSTALLATION)

(STEP 2 CONTINUEDON NEXT PAGE)

24