ParaBody 425 manual Sep

Page 5

318 X 2-3/4"~

1

/

/

 

I

/

/

 

/

 

I

/

 

I

/

//

 

//

/

 

 

 

 

 

 

/

 

 

 

/

 

112X 3-t12"

 

 

 

3/8 X 2"

Sep 2

A.SECURELYassemble one 3-1/2 X 1 IN. PULLEY (100) to the PRESS LEVER (15) as shown drawing, using one 5/8 X 2-5/4 IN. BOLT (75), fwo 5/8 IN. FLANGE SPACERS(97), and one 5/8 LOCK NUT (91).

B.SECURELYassemble one 4-1/2 X 1 IN. PULLEY (99) fo the HORIZONTAL FLAT of ~he

PRESSBASE (1) using one 5/8 X 2 IN. BOLT (76), one 2-7/8 IN. CABLE RETAINING CLIP (57), one 5/8 IN. WASHER(69), and one 5/B IN. LOCK NUT (91).

C.Aflach two 1 X 1 IN. GUIDES (45) to fhe UNDERSIDEof fhe PRESSLEVER (15), as shown.

D.Inserf two 1/2 IN. FLANGEBEARINGS(95) into fhe PRESSLEVER (15) as shown on drawing.

E.Assemble the PRESS LEVER (15) to the PRESS BASE (1) us shown on drawing, using one 1/2

5-1/2 IN. BOLT (68), two 1/2 IN. WASHERS(65), and one 1/2 IN. LOCK NUT (90). (TIGHTEN CONNECTIONENOUGHTO REMOVETHE PLAY, YET ALLOWING THE PRESS LEVER TO ROTATE FREELY.

F.Inserf fwo 1/2 IN. FLANGEBEARINGS(95) ino the PRESSSUPPORTTUBE (8) as shown.

G.Assemble the PRESS SUPPORTTUBE (8) fo the PRESSBASE (1) as shown on drawing, using one 1/2 X 5-1//2 IN. BOLT (68), fwo 1/2 IN. WASHERS(65), and one 1/2 IN. LOCK NUT (90).

(TIGHTEN THE CONNECTIONENOUGHTO REMOVETHE PLAY, YET ALLOWING THE PRESS SUPPORT TUBE TO ROTATEFREELY).

6

Image 5
Contents SeriousSteel Ii/i/I CAP Joint CONNECTOR3/8 58 6214401 PIN WeightstackselectorLabel WEIGHTSTACK1-25 WeightplateI I AssemblyInstructionsStep Sep Step Sfep Step Step ~ep I12 I I12Siep IMPORTANT!!! Tighten the NUT FROMPAGE12~ep1 PUSH/PULL Cable Sfep 1 Press AdjustmenttubeSep 1 Sfep 1 ~ Page IMPORTANT!! Tighten the NUT Spring PIN Assemblysecurely Important !!! Tighten the NUT of the Spring AssemblysecurelyPress Back Support to Rotate Freely PIN AssemblysecurelyCable Guide On Next LAT CA~LE Cable Form a Loop in the Center of the Cable III Extension 3CK Threadedshaft LATX 1 IN. Button Head CAP SCREWS78 TOPBO0 M---~ Sep B