ParaBody 425 manual Sfep 1, Press Adjustmenttube

Page 15

\

\/

/

\

/

\/

\

Sfep 1 4

A.Affach four PARAGLIDESTRIPS /50) inside fhe end of fhe RECEIVING TUBE (17), and four PARAGLIDESTRIPS (50) outside the end of he PRESSADJUSTMENTTUBE I12) using

following steps:

*Thoroughly clean all surfaces where the PARAGLIDESTRIPS (50 / are to be aftached.

*Remove the PARAGLIDESTRIPS (50) from the paper backing and firmly apply them to all shown surfaces.

B.Carefully slide the PRESSADJUSTMENTTUBE (12) into the RECEIVING TUBE (17). (MAKE SURE SPRING PIN BARREL ON THE RECEIVING TUBE (17) IS ON THE SAME SIDE AS THE HOLES

IN THE PRESS ADJUSTMENTTUBE)

C.Insert two 1/2 IN. FLANGE BEARINGS(95) into the PRESSLEVER (15) as shown on drawingZ

D.Assemble the PRESS ADJUSTMENTTUBE (12) to the PRESSLEVER (15) as shown on drawing, using 1/2 X 4 IN. BOLT (66), fwo 1//2 IN. WASHERS(65), and one 1/2 IN; LOCKNUT (90).

(TIGHTEN THE CONNECTIONENOUGHTO REMOVETHE PLAY, YET ALLOWINGTHE RECEIVING TUBE (17) TO ROTATEFREELY)

16

Image 15
Contents SeriousSteel Ii/i/I Weightplate 58 6214401 PIN WeightstackselectorCAP Joint CONNECTOR3/8 Label WEIGHTSTACK1-25AssemblyInstructions StepI I Sep Step Sfep Step Step ~ep I12 I I12Siep IMPORTANT!!! Tighten the NUT FROMPAGE12~ep1 PUSH/PULL Cable Sfep 1 Press AdjustmenttubeSep 1 Sfep 1 ~ Page IMPORTANT!! Tighten the NUT Spring PIN Assemblysecurely Important !!! Tighten the NUT of the Spring AssemblysecurelyPress Back Support to Rotate Freely PIN AssemblysecurelyCable Guide On Next LAT CA~LE Cable Form a Loop in the Center of the Cable III Extension 3CK Threadedshaft LATX 1 IN. Button Head CAP SCREWS78 TOPBO0 M---~ Sep B