ParaBody 425 manual Press Back Support to Rotate Freely, PIN Assemblysecurely

Page 21

× 3-]./2"

A.Inserf ~wo I/2 IN. FLANGE BEARINGS(95) into ~he PRESS SUPPORTTUBE 18) as shown.

SECURELYassemble the PRESS BACK SUPPORT(3) fo the PRESS SUPPORTTUBE (8) as shown drawing, using one 1/2 X 5-1/2 IN. BOLT (68), fwo 1/2 IN. WASHERS(65), and one 1/2 LOCK NUT (gO). (TIGHTEN THE CONNECTIONENOUGHTO REMOVETHE PLAY, YET ALLOWING

PRESS BACK SUPPORT TO ROTATE FREELY)

Go SECURELYassemble one 1/2 IN. SPRING PIN ASSEMBLY(51) to the SPRING PIN HOUSING,

the

PRESS SUPPORTTUBE (8) as shown. (!!! IMPORTANT!!! TIGHTEN THE NUT OF THE SPRING

PIN

ASSEMBLYSECURELY)

22

Page 20 Page 22
Image 21
Page 20 Page 22
Contents SeriousSteel Ii/i/I CAP Joint CONNECTOR3/8 58 6214401 PIN WeightstackselectorLabel WEIGHTSTACK1-25 WeightplateAssemblyInstructions StepI I Sep Step Sfep Step Step ~ep I12 I I12Siep IMPORTANT!!! Tighten the NUT FROMPAGE12~ep1 PUSH/PULL Cable Sfep 1 Press AdjustmenttubeSep 1 Sfep 1 ~ Page IMPORTANT!! Tighten the NUT Spring PIN Assemblysecurely Important !!! Tighten the NUT of the Spring AssemblysecurelyPress Back Support to Rotate Freely PIN AssemblysecurelyCable Guide On Next LAT CA~LE Cable Form a Loop in the Center of the Cable III Extension 3CK Threadedshaft LATX 1 IN. Button Head CAP SCREWS78 TOPBO0 M---~ Sep B
Top Page Image Contents