S~ep1 1
A.
~SECURELYossemble one of the BACK/SEAT PADS (.55) X 5 IN. BOLTS (75), two 5/8 IN. LOCK WASHERS(70),
fo the PEC SEAT (21), using two and two 5/8 iN. WASHERS(69).
~Assemble two ROLLER PADS (50) fo the PEC SEAT (21) as shown on draw;ng, using one ROLLER PAD SHAFT (55), and two 9/16 MUSHROOMCAPS
B.Attach eight PARAGLIDESTRIPS (50) to the FRONTUPRIGHT(22) using the following steps:
*Thoroughly clean all surfaces where the PARAGLIDESTRIPS (50) are to be attached.
~Remove the PARAGLIDESTRIPS from the paper backing and firmly apply them to surfaces.
C. Pull beck the SPRING PIN (49) on the FRONTUPRIGHT(22) and insert the PEC SEAT (21) down desired height. Release the SPRINGPIN (49) and allow if to engage into the adiusfment holes. Use the THUMBSCREW(46) to tighten the PEC SEAT (21) in place.
Attach eight PARAGLIDESTRIPS (50) to the ADJUSTABLEROLLERPAD SLEEVE (24) as shown, and using the following steps:
¯Thoroughly clean all surfaces where the PARAGLIDESTRIPS are to be attached.
¯Remove the PARAGLIDESTRIPS (50) from the paper backing and firmly apply them to surfaces.
t4