ParaBody 425 manual IMPORTANT!! Tighten the NUT Spring PIN Assemblysecurely

Step 1 9

A.LOOSELY assemble two 3-1/2 X 1 IN. PULLEYS (100) and two 2-3/8 IN. CABLE RETAINING CLIPS (62) to the CENTERPULLEY BRACKET(10) using two .5/8 X 2 IN. BOLTS (76), two 3/8 IN. WASHERS(69), and two 5/8 LOCK NUTS (91).

(NOTE: THIS CONNECTIONWILL BE TIGHTENED AFTER THE CABLE HAS BEEN ROUTED)

Step 20

A. Assemble two 3/4 IN. THRUST WASHERS(94) and two PEC CAMS(9) fo the LEFT (19) and RIGHT PEC ARMS, as shown on drawing.

B. Insert four ,5/4 IN. FLANGEBEARINOS(93) into the BUSHINGSof the BEARING HOUSING(18).

Go Insert the LEFT (19) and RIOHT (20) PEC DEC through the 3/4 IN. FLANGEBEARINGS(95) in the BEARINGHOUSINO(18) on ~heir respective sides us shown on drawing, end SECUREthem in place with two 3/4 I.D. STAR LOCKCOLLARS(54).

Slide two 4 X 12 ROLLERPADS (29) onto the LEFT (19) and RIGHT PEC DEC ARMS(20), until ROLLER PAD (29) is FLUSH with the bottom ~he ARMS.

(NOTE: IF A LUBRICANTIS REQUIRED, COAT THE INSIDE OF THE ROLLER PAD WITH RUBBING ALCOHOLOR WATER. ALSO, ROTATING THE PAD WHILE PUSHING UP WILL HELP TO EASE ASSEMBLY)

SECURELYassemble two 3/8 IN, SPRING PIN ASSEMBLIES(49) to the SPRINGPIN BARRELS, of the PEC CAMS.

(!!! IMPORTANT!!} TIGHTEN THE NUT OF THE

SPRING PIN ASSEMBLYSECURELY)

I

I

20