ParaBody 425 manual Step

Page 8

3/8 X 3",

Step 5

A. LOOSELY assemble fhe PRESS BASE (1) to the REAR (15) AND MIDDLE UPRIOHTS (11),using

four 5/8 X 5 IN. BOLTS (75), eight 5/B IN. WASHERS(69), and four 5/8 IN. LOCK NLTS (91).

B.LOOSELY assemble fhe PRESS BASE (1) to the BASE (7) using two 1/2 X 5-1/4 IN. BOLTS (67), four 1/2 IN. WASHERS(65), ~nd two 1/2 IN. LOCK NUTS (90).

3

4

5

6

9

Image 8
Contents SeriousSteel Ii/i/I 58 6214401 PIN Weightstackselector CAP Joint CONNECTOR3/8Label WEIGHTSTACK1-25 WeightplateI I AssemblyInstructionsStep Sep Step Sfep Step Step I12 I I12 ~epSiep FROMPAGE12 IMPORTANT!!! Tighten the NUT~ep1 PUSH/PULL Cable Press Adjustmenttube Sfep 1Sep 1 Sfep 1 ~ Page IMPORTANT!! Tighten the NUT Spring PIN Assemblysecurely Assemblysecurely Important !!! Tighten the NUT of the SpringPIN Assemblysecurely Press Back Support to Rotate FreelyCable Guide On Next LAT CA~LE Cable Form a Loop in the Center of the Cable III Extension LAT 3CK ThreadedshaftTOPBO0 M---~ Sep B X 1 IN. Button Head CAP SCREWS78