Precor Installation and Assembly Guide for the 9.1 Treadmill

Page 13

Diagram 7

Incline crank handle Incline handle screw

Incline crank shaft

Install incline
crank handle
		DISTANCE
ERGO/SMART		TIME
ERGO/SMART		SPEED
		CALORIES
		INCLINE
		MODE
		MODE
		ENTER
		STOP
		TORESET
	SPEED	HOLD
	SPEED
		OFF
		ACTIVATE
		CAUTION

	19. Install the incline crank handle (M9.1 only) onto the lift column shaft as shown in Diagram 7.
	Align the handle with the flat portion of the shaft end. Insert a screw (D) through the handle
	and crank shaft and tighten the screw securely with the hex key (G) provided. Do not
	overtighten.
Diagram 8	Attach trim strip to
	lift column

Notched end of trim strip

Velcro strip

Ribbon cable

Lift column

Trim strip

20.Attach the lift column trim by following these steps. While performing these steps, refer to Diagram 8 for further clarification.

a.Position the trim strip so that the notched end points up. See Diagram 8.

b.Insert the base of the trim through the opening in the hood.

	CAUTION: Make sure that the ribbon cable is	c.	Raise the trim until the notched end of the trim touches the underside of the upper
	situated in the trim strip’s center slot before		handrail clamp. Be careful to maintain vertical alignment of the trim with the lift column.
	you take the next step. Cables crimped or	d.	While maintaining alignment, attach the trim by pressing firmly against the lift column
	pinched due to inaccurate assembly may not	d.
	pinched due to inaccurate assembly may not		until the Velcro pads fasten securely to each other.
	be covered by the limited warranty.		until the Velcro pads fasten securely to each other.
	be covered by the limited warranty.

page 7

Image 13

Contents Precision Electronic Treadmill Important Safety Instructions Precor Smart Weights-Safety Guidelines Personal SafetyFCC Communications Commission, part Information Regarding International UseGrounding Instructions Diagram aTable of Contents Unpacking the M9.1 or M9.2s Treadmill Before You BeginOptional Equipment BCD Installation Requirements Setting Up the M9.1 or M9.2s TreadmillAssembly Instructions Column Install liftBoard PlugFlanged nuts a Base plate Motor chassis Cross beam HandrailAttach electronic console to Handrail clamp not shownHandrail clamp Attach trim strip to OvertightenLift column Handrails See Aligning the Running Belt Checking the Alignment of the Running BeltLocating the on and OFF Switch Using the M9.1 or M9.2s TreadmillUsing the Magnetic Safety Key Displays on the Electronic Console Understanding the Electronic ConsoleScan Keys on the Electronic ConsoleSelecting the Time or Distance Prompt on the M9.2s Changing the Display to U.S. Standard or MetricTreadmill Working Out on Your TreadmillQuick Steps to Working Out Changing Incline on the M9.1 Pausing Your WorkoutRetrieving the Previous Workout Program Cooling Down After a WorkoutChanging the Interval Course Profile Using the Manual Course ModeUsing the M9.2s Preprogrammed Courses Page Erector Spinae Gluteals Hip Flexors Getting the Most Out of Your WorkoutHow Hard Should I Exercise? Heart Rate Training ZoneHow Often Should I Exercise? How Long Should I Exercise?Maintaining Your Treadmill Cleaning the EquipmentAligning the Running Belt Running belt Adjusting the Tension of the BeltSide platform Running bed Rear roller Obtaining Service Power Cord MaintenanceServicing the Treadmill M9.1 or M9.2s Long Term StorageElectronic Specifications SpecificationsElectronic Displays