Precor c954, c956 owner manual Secure

C O M M E R C I A L		P R O D U C T S	D I V I S I O N
Diagram 11	Secure the right	1
	upright support.
	Screws (D),
	washers (E),
	and barrel
	spacers (F)
	Tighten so that
	the upright is
	secure, but
	leave room for
	adjustments.
	Front panel
	Shipping		3
	fasteners with	2
	washers (B)

8.Secure the right side upright support. Diagram 11. Obtain two long sockethead screws (D), washers (E) and barrel spacers (F) from the Hardware kit. Place a washer and barrel sleeve on each bolt and insert the fasteners through the side of the upright support and into the base mounts. Diagram 11, #1. Secure the upright support using the 1/4-inch hex key. See Diagram 11, #2.

Important: Do not securely tighten the screws until after the unit has been fully assembled. Make sure that the bolt and spacer do not pinch the cable.

9.Remove two stainless steel washers (B) from the Hardware kit and place one on each of the two bolts removed in step 7a. Reinsert the bolts and finger tighten. Diagram 11, #3.

Diagram 12	Secure the
	display console.
	Display console
	1-inch screws (A)
	with washers (B)
	Tighten the
	screws, but
	leave room for
	adjustments.

10.Secure the display console to the upright supports. Diagram 12, #1. Align the display console with the right side upright support mounts.Insert two 1-inch screws (A) with washers (B) and finger tighten. Use the supplied hex key to secure the screws on both upright supports, but leave room for adjustments. See inset in Diagram 12, #2.

page 15