Precor c954, c956 owner manual Diagram

C O M M E R C I A L P R O D U C T S D I V I S I O N

Diagram 14	Replace the	1	2
	hood and
	secure it.
	Hood
	Buttonhead
	screws (A) with
	washers (B)
	secure the hood
	to the siderail.

Buttonhead screws (A) with washers (B) secure the front of the hood.

12.Replace the hood. Diagram 14. Reposition the hood on the treadmill. Remove four buttonhead screws (A) with washers (B) from the hardware kit. Two buttonhead screws and washers are placed through the front panel and the remaining two screws and washers are used to secure the hood to the siderail. Tighten the screws using the appropriate hex keys.

Diagram 15	Secure the	2
	fasteners and
	replace the
	hood.
	Alternately
	tighten four
	side upright
	screws.
	Alternately	3
	tighten the four
	front panel	1
	screws.
	Alternately tighten
	the four screws
	that secure the
	display console.

13.Tighten all mounting screws with the hex keys provided. Diagram 15. Start at the front of the treadmill with the four screws that attach the upright supports to the front panel.Tightening these screws first helps pull the rest of the treadmill’s parts into alignment. Then, proceed with tightening the four sockethead screws (D) that secure the upright supports, the four console assembly screws (A), the handrail assembly screws (A) and (C), and the hood screws (shown in Diagram 14).

page 17