ProForm PFTL51330 user manual Troubleshooting, Problem The power does not turn on, Solution

TROUBLESHOOTING

Most treadmill problems can be solved by following the instructions below. If further assistance is

needed, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor

is plugged into a properly grounded outlet (see page 10). Use only a single-outlet surge suppres- sor that meets all of the specifications described on page 10. Important: The treadmill is not com- patible with GFCI-equipped outlets.

b. Make sure that the key is fully inserted into the console.

c.Check the reset/off circuit breaker located on the frame near the power cord. If the breaker protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the breaker back in.

PROBLEM: The power turns off during use

SOLUTION: a. Check the reset/off circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c. Remove the key from the console and then reinsert it.

c

Off Reset

PROBLEM: The displays of the console do not function properly
SOLUTION:	a. Remove the key from the console and		UNPLUG THE	a
	POWER CORD.	With the help of another person,
					6
	carefully tip the Base (109) down as shown. Remove
	the two 3/4”Screws (6). Note: A phillips screwdriver
	with at least a 5” shaft is required.
					109
	With the help of another person, carefully raise the
	Right Upright (82) and the Left Upright (69) as shown.			69	39
	Carefully pivot the Hood (39) off.				82

26