ProForm PFTL51330 user manual Aged When the Power is Turned on

5.Attach the Console Back (95) to the console assembly with five 3/4” Screws (6).

6. With the help of another person, hold the console as- sembly near the Right Upright (82) and the Left Upright (not shown).

Connect the Wire Harness (83) to the wire harness in
the console assembly.			Make sure to connect the con-
nectors properly (see the inset drawing); the con-
nectors should slide together easily and snap into
place.	If the connectors do not slide together easily and
snap into place, turn one connector and try to connect
them again.		IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.				Insert the
wire harnesses down into the Right Upright (82).

Set the console assembly on the Right Upright (82) and

the Left Upright (no t shown). Thread two 1” Bolts (71) with 1/4” Star Washers (92) into each side of the console

assembly. After you have started all four Bolts, tighten them.

7. With the help	of another person, lower the console as-
sembly (not	shown) to the floor.	Have the other person

hold the treadmill steady during this step.

Insert the two Wheels (108) into the Wheel Housings
(106). Insert the Wheel Housings and the Wheels into
the Base (109) as shown. (Note		: It may be helpful to use
a rubber mallet to fully insert the Wheel Housings.)			Open
part bag C.	Attach the Wheel Housings to the Base with
two Wheel Bolts (107) and two Wheel Nuts (21) as
shown.	Do not overtighten the Wheel Bolts.

Center the Frame (54) between the Uprights (69, 82). Tighten the four 5/16” x 3 1/2” Bolts (93). Raise the Uprights (69, 82) to the vertical position.

5	Console Assembly
			6
	6	95	6
6
	Console
	Assembly
			83
			92
		82	71
	83
7		69	108
			106
54		21	107
			93
			109
82
93

8