Plug the Power Cord, Unplug the Power Cord

Locate the Reed Switch (24) and the Magnet (18) on
the left side of the Pulley		(120). Turn the Pulley until
the Magnet is aligned with		the Reed Switch.		Make
sure	that the gap between the	Magnet and the
Reed	Switch is about 1/8”.		If necessary, loosen the

Screw (25) and move the Reed Switch slightly. Retighten the Screw. Reattach the Hood. Make sure the Screws are return to the correct holes (see step A). Run on the treadmill for a few minutes to check for a correct speed reading.

1/8”

Top

View

120

PROBLEM: The walking belt slows when walked on
SOLUTION:	a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 10.
	b. If the walking belt is overtightened, treadmill perfor-			b	3–4”
	mance may decrease and the walking belt may be			b	3–4”
	permanently damaged. Remove the key and		UN-
	PLUG THE POWER CORD	. Using the included allen
	wrench, turn both rear roller adjustment bolts counter-
	clockwise 1/4 of a turn. When the walking belt is prop-
	erly tightened, you should be able to lift		the edges	of
	the walking belt 3 to 4 inches off the walking platform.
	Be careful to keep the walking belt centered. Plug in			Rear Roller Adjustment Bolts
	the power cord, insert the key, and run the treadmill			Rear Roller Adjustment Bolts
	for a few minutes. Repeat until the walking belt is
	properly tightened.


PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION:	a. If the walking belt is off-center, first remove the key
	and UNPLUG THE POWER CORD		. If the walking
	belt has shifted to the left,		use the allen wrench to
	turn the left rear roller bolt clockwise 1/2 of a turn;			if
	the walking belt has shifted to the right,			turn the
	bolt counterclockwise 1/2 of a turn. Be careful not to
	overtighten the walking belt. Plug in the power cord,
	insert the key, and run the treadmill for a few minutes.
	Repeat until the walking belt is centered.
	b. If the walking belt slips when walked on, first remove
	the key and	UNPLUG THE POWER CORD		. Using
	the allen wrench, turn both rear roller bolts clockwise
	1/4 of a turn. When the walking belt is correctly tight-
	ened, you should be able to lift each side of the walk-
	ing belt 3 to 4 inches off the walking platform. Be
	careful to keep the walking belt centered. Plug in the
	power cord, insert the key, and walk on the treadmill
	for a few minutes. Repeat until the walking belt is
	properly tightened.

Switch is about 1/8”.

SOLUTION:

PLUG THE POWER CORD

. Using the included allen

the edges

SOLUTION:

belt has shifted to the left,

turn the

UNPLUG THE POWER CORD

. Using