ProForm PFTL51330 user manual Only the right side is shown, Tighten the Bolts yet

2. Attach the six Base Pads (100) (three are shown) to the
bottom of the Base (109) with six 3/4” Tek Screws (47).
Note: The 3/4” Tek Screws are found in	part bag C	.

3. With the help of another person, raise the Right Upright

(82)and the Left Upright (not shown) to the vertical posi- tion. Hold the Crossbar (90) between the Uprights, and align the notches in the Crossbar with the indicated

welds on the Uprights. Attach each end of the Crossbar

with a 3/8” x 3 1/2” Bolt (81) and a Crossbar Endcap (84)

(only the right side is shown).	Make sure that the
Crossbar Endcaps are turned so the notches are
aligned with the welds on the Uprights. Do not
tighten the Bolts yet.

4.Turn the Console Base (85) upside-down; be careful not to scratch the Console Base. Remove the bands and the Console Back (not shown) from the Console Base. Hold the ends of the Pulse Bar (110) against the Console Base as shown. Connect the Pulse Wire (118) in the Console Base to the pulse wire in the Pulse Bar (see the inset drawing). The connectors should slide together

easily and snap into place.If the connectors do not

slide together easily and snap into place, turn one con- nector and try to connect them again.

Open part bag B. Have another person hold the Pulse

Bar (110) firmly against the underside of the Console

Frame (7). Attach the Pulse Bar with four Pulse Bar

Screws (68) (only two are shown). Note: The Pulse Bar

Screws may be preattached and may need to be re-

moved. Firmly tighten the Screws. Be careful not to damage the wires.

Attach the round ring on the ground wire to the Console

Frame (7) with a 1/2” Ground Screw (114). Note: There are no wires on the other side of the Pulse Bar (110).

2
		100	47
100
47
		109
100
47
3
90
	82
	84
Notch		81
Welds
	Notch
4
110	68	114
85			7
118
Ground
Wire
118

7