Basic Operations, Input mode, On the remote control

Basic Operations

Selecting the Analog or Digital Input Mode

Changing the Digital Input Mode Manually

When you have connected digital source components using both the analog connection and the digital connection methods (see pages 7 to 10), you can select the input mode.

•Before selecting the digital input mode, register the digital input terminal setting correctly (see “Digital input (DIGITAL IN) terminals” on page 25).

If the following symptoms occur while Dolby Digital or DTS Digital Surround software is played back, you can change the digital input mode:

•Sound does not come out at the beginning of playback.

•Noise comes out while searching for or skipping chapters or tracks.

1Press one of the source selecting buttons (STB, TV, or CDR) for which you want to change the

input mode.

DVD

STB

VCR

TAPE/CDR

FM/AM

On the front panel

CONTROL

SOURCE NAME

On the front panel

TV TAPE CDR FM/AM

TV DIRECT STB

VCR

DVD

From the remote control

Note:

•You cannot change the input mode when selecting DVD as the source. Digital input is always used for the built-in DVD player.

2Press INPUT ANALOG/DIGITAL (INPUT ATT.) on the front panel or ANALOG/DIGITAL INPUT

on the remote control.

INPUT
ANALOG/DIGITAL	ANALOG
	/DIGITAL
	INPUT
INPUT ATT.

On the front panel

From the remote control

The current input mode appears on the display.

•Each time you press the button, the input mode alternates between the analog input (“ANALOG”*) and the digital input (“DGTL AUTO”).

ANALOG/DIGITAL AUTO indicator

ANALOG DIGITAL AUTO

L	R	SPK.
		VOLUME

Press CONTROL 3 (or 2) to select “DGTL D.D.” or “DGTL DTS” while “DGTL AUTO” still remains on the display.

•Each time you press the button, the digital input mode changes as follows:

DIGITAL AUTO
L	R	VOLUME
		VOLUME

DGTL AUTO				DGTL D.D.
DGTL AUTO				DGTL D.D.

DGTL DTS

DGTL AUTO : Normally select this.

The DIGITAL AUTO indicator lights up. The unit automatically detects the incoming signal format, then the sound signal indicator for the detected signal lights up.

DGTL D.D. : Select this for playing back software encoded with Dolby Digital.

The	DIGITAL indicator lights up*.

DGTL DTS : Select this for playing back software encoded

with DTS Digital Surround.

The indicator lights up*.

*These indicators flash when no signal or the signal without the proper format is played back.

When DVD is selected as the source, you can also

ANALOG

change the digital input mode by pressing/DIGITAL

DGTL AUTO				ANALOG
DGTL AUTO				ANALOG

* “ANALOG” is the initial setting except for the built-in DVD

ANALOG/DIGITAL INPUT repeatedly on the remote control.

Notes:

INPUT

player.

DGTL AUTO : Select this for the digital input mode. The DIGITAL AUTO indicator lights up. The unit automatically detects the incoming signal format, then the sound signal indicator for the detected signal—DIGITALor lights up; otherwise, no sound signal indicators light up.

ANALOG : Select this for the analog input mode. The ANALOG indicator lights up.

•When “DGTL AUTO” cannot recognize the incoming signals, no sound signal indicators light up on the display.

•When you turn off the unit or select another source, “DGTL DTS” and “DGTL D.D.” are canceled.

The digital input mode is automatically reset to “DGTL AUTO.”