JVC RX-DV5RSL Enter the manufacturer’s code, Using the number buttons, Release STANDBY/ON STB

7To change the transmittable signals for operating other manufacturers’ STB

1.	Press and hold		STANDBY/ON
	STANDBY/ON STB.	STB	VCR	TV	AUDIO
2.	Press STB.	TV	TAPE	CDR	FM/AM
		TV DIRECT	STB	VCR	DVD

3. Enter the manufacturer’s code	EFFECT	CENTER
	1	2	3
using the number buttons (1–9,	TEST	REAR·L
0).	4	5	6
	SURR ON/OFF	REAR·R
See the right to find the code.	7	8	9
	SURR MODE – SUBWOOFER +
	10/0	+10
		100+

4. Release STANDBY/ON STB.

You can turn on and off the STB:

STANDBY/ON STB : Turns on or off the STB.

After pressing STB, you can perform the following operations on an STB:

TV/STB CH + or – :Changes the channels.

1 – 9, 0, 100+ : Selects the channels.

For channel number 5, press 5.

For channel number 10, press 1, then 0. For channel number 23, press 2, then 3. For channel number 135, press 100+, 3, then 5.

TV RETURN will function as the ENTER button if your equipment requires pressing ENTER after selecting a channel number.

Note:

• Refer also to the manual supplied with your STB.

5.Try to operate your STB by pressing

STANDBY/ON STB.

When your STB turns on or off, you have entered the correct code.

If there are more than one code listed for your brand of STB,

try each one until the correct one is entered.

Manufactures’ codes for STB

Manufacturer	Codes
JVC	56*, 57, 67
Amstrad	43 – 49
Blaupunkt	30
Echostar	50, 51, 67
General Insrument	29
Goldstar	31
Grundig	32, 33
Hemlin/Re	01 – 05
Hirschmann	48, 52 – 55
Instrument	68
Itt/Nokia	34
Jerrold/G	06 – 14
Kathrein	52, 58 – 63
NEC	35, 36
Oak	15 – 17
Orbitech	48
Panasonic	18 – 20
Philips	37, 38
Pioneer	21, 22
RCA	65
Samsung	39, 40
Schwaiger	61, 64
Scientiff	23 – 25
Siemens	41, 42
Sony	66
Technisat	48
Tocom	26
Zenith	27, 28

*“56” is the initial JVC code.

Note:

•Manufacturers’ codes are subject to change without notice. If they are changed, this remote control cannot operate the equipment.

66