JVC RX-DV5RSL Sound Adjustments, Press Adjust, Press Control ∞ or Repeatedly until BAL Balance

Sound Adjustments

The following settings are required after connecting and positioning your speakers.

You can adjust the items by using the ADJUST button and CONTROL 5/∞/2/3 buttons on the front panel.

Adjustment items:

•	Front speaker output balance*	• Tone*	• Speaker output levels*
•	DAP effect level

Notes:

•The setting contents of adjustment items are memorized for each source. * You can also set these items using the Choice menu (see pages 53 to 58).

Operation Buttons

To do the basic settings for this unit, use the buttons on the front panel.

ADJUST

CONTROL

	On the front panel ONLY*
Button		To do
ADJUST		Display the adjustment indications on
		the display**.
CONTROL 5/∞		Select an item on the display.
		Each time you press the button, the
		indication changes as illustrated below.
CONTROL 3/2		Adjust the selected item.

•When no operation is done for about 5 seconds, the indications on the display will disappear.

*You can also make sound adjustment except for front speakers output balance from the remote control.

**Pressing ADJUST repeatedly also changes the indication.

Configuration of the indications on the display

BAL	EFFECT ##
(Balance)
BASS	REAR R#
	(Rear right)
TREBLE
	REAR L#
	(Rear left)
SUBWFR#
	CENTER #
(Subwoofer)

#These indications appear only when the corresponding speakers information for each speaker is set to other than “NO.”

##“EFFECT” appears only when one of DAP modes (see pages 29 to 32) is activated.

Operating Procedure

Ex. : When setting the front speaker output balance.

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

1 Press ADJUST.		ADJUST
The CONTROL buttons now work for sound
adjustments. The setting item selected previously
appears on the display.
2 Press CONTROL ∞ (or 5)
repeatedly until “BAL (Balance)”		CONTROL
(with the current setting)* appears
on the display.
DIGITAL AUTO
L R	SPK.	VOLUME

*“CENTER” is the initial setting. If you have already changed the setting, another setting will be shown.

3 Press CONTROL 3 (or 2) to adjust

the front speaker balance. CONTROL

•Each time you press the button, the indication changes as follows:

DIGITAL AUTO
L	R	SPK.
		VOLUME

R –21 CENTER L –21

27