Attenuating the Input Signal, Input ATT indicator

Attenuating the Input Signal

When the input level of the analog source is too high, the sounds will be distorted. If this happens, you need to attenuate the input signal level to prevent the sound distortion.

•You have to make this adjustment for each analog source.

	INPUT
On the front panel ONLY	ANALOG/DIGITAL
On the front panel ONLY
	INPUT ATT.

Press and hold INPUT ATT. (INPUT ANALOG/ DIGITAL) until the INPUT ATT indicator lights up on the display.

•Each time you press and hold the button, the Input Attenuator turns on (“ATT ON”) or off (“ATT NORMAL”*).

		INPUT ATT indicator

ANALOG		INPUT ATT
L	R	VOLUME
		VOLUME

ATT NORMAL ATT ON

* “ATT NORMAL” is the initial setting.

ATT NORMAL : Normally select this. The analog sound is not attenuated.

ATT ON	: Select this when the analog sound is
	distorted.

Changing the Source Name

When you connect an CD recorder to the TAPE/CDR jacks on the rear panel, change the source name which will be shown on the display.

TAPE/CDR

SOURCE NAME

On the front panel ONLY

Ex. : When changing the source name from “TAPE” to “CDR”

1Press TAPE/CDR (SOURCE NAME) to select as the source.

2Press and hold SOURCE NAME (TAPE/CDR) until “ASSGN. CDR” appears on the display.

ANALOG

VOLUME

ASSGN. TAPE ASSGN. CDR

To change the source name to “TAPE”

Press and hold SOURCE NAME (TAPE/CDR) until “ASSGN. TAPE” appears on the display in step 2.

Note:

•Without changing the source name, you can still use the connected components. However, there may be some inconveniences:

–The unexpected source name will appear on the display when you press TAPE/CDR (SOURCE NAME) on the front panel.

–The CDR or TAPE button on the remote control cannot work for selecting the source.

–You cannot use the digital input (see page 8) for the CD recorder.

Activating the Recording Mode

When you play back the multichannel sources, Recording mode enables you to record the sounds without missing surround elements by down-mixing the center and rear channel signals into the front channel signals.

•For DVD AUDIO ONLY: When the multichannel track cannot be down-mixed, this function does not take effect.

•When the multichannel software is played back with Recording mode activated, the sounds are down-mixed and come out through the front speakers only.

SURROUND

ON/OFF MODE

On the front panel ONLY

REC MODE

Press and hold REC MODE (SURROUND MODE) until “RECMODE ON” appears on the display.

•Each time you press and hold the button, Recording mode is activated (“RECMODE ON”) and deactivated (“RECMODE OFF*”) alternately.

* “RECMODE OFF” is the initial setting.

RECMODE OFF : Normally select this. The down-mixing is canceled.

RECMODE ON : Select this for recording the down-mixed sounds.

When recording with VCR:

You can record the picture on your video tape without the volume level indication when Recording mode is activated.

•When you do not want to record the on-screen guide icons, see page 58.

•The choice menu and on-screen bar are always recorded when they appear on the TV.

CAUTION:

When the front speakers are small, the output sound may be distorted by Recording mode. In this case, decrease the volume until the sound distortion diminishes.

Notes:

•When you turn off the unit or select another source, Recording mode is canceled (“RECMODE OFF”).

•Sound adjustments (see pages 27 and 28) and Surround modes (see pages 29 to 32) do not affect the recording.

•The following buttons do not work while Recording mode is activated (“RECMODE ON”):

–SETTING and ADJUST on the front panel.

–SURROUND ON/OFF and SURROUND MODE on the front panel.

–Number buttons for adjusting sound on the remote control.