JVC RX-DV5RSL manual Important for Laser Products

Page 2

Warnings, Cautions and Others

IMPORTANT for the U.K.

DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer.

BE SURE to replace the fuse only with an identical approved type, as originally fitted.

If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply.

If this product is not supplied fitted with a mains plug then follow the instructions given below:

IMPORTANT

DO NOT make any connection to the terminal which is marked with the letter E or by the safety earth symbol or coloured green or green-and-yellow.

The wires in the mains lead on this product are coloured in accordance with the following code:

Blue : Neutral

Brown : Live

As these colours may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

CAUTION

Do not block the ventilation openings or holes.

(If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.)

Do not place any naked flame sources, such as lighted candles, on the apparatus.

When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must be followed strictly.

Do not expose this apparatus to rain, moisture, dripping or splashing and that no objects filled with liquids such as vases, shall be placed on the apparatus.

Caution: Proper Ventilation

To avoid risk of electric shock and fire and to protect from damage. Locate the apparatus as follows:

Front: No obstructions open spacing. Sides:No obstructions in 10 cm from the sides. Top: No obstructions in 10 cm from the top. Back: No obstructions in 15 cm from the back

Bottom: No obstructions, place on the level surface.

In addition, maintain the best possible air circulation as illustrated.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

IF IN DOUBT—CONSULT A COMPETENT ELECTRICIAN.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

Wall or

obstructions

Spacing 15 cm or more

RX-DV5RSL

Front

Stand height

15 cm or more

Caution— STANDBY/ON button!

Disconnect the mains plug to shut the power off completely. The

STANDBY/ON button in any position does not disconnect the mains line. The power can be remote controlled.

Floor

IMPORTANT FOR LASER PRODUCTS

REPRODUCTION OF LABELS

1 CLASSIFICATION LABEL ON EXTERIOR SURFACE

2 WARNING LABEL INSIDE THE UNIT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1.CLASS 1 LASER PRODUCT

2.CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.

3.CAUTION: Do not open the top cover. There are no user serviceable parts inside the Unit; leave all servicing to qualified service personnel.

G-1

Image 2
Contents RX-DV5RSL Important for Laser Products Above ALL Table of Contents Front Panel Adjust button 27Parts Identification DisplayPTY 9 and buttons Display button Remote ControlParts Identification Getting Started Before Installation Putting Batteries in the Remote ControlChecking the Supplied Accessories AM antenna connection Connecting the FM and AM AntennasGetting Started FM antenna connectionConnecting the front, center, and rear speakers Connecting the SpeakersConnecting the subwoofer speaker Speaker Layout DiagramFor Scart connections Connecting Audio/Video ComponentsAbout connecting cables/cords For audio connectionsCassette deck/CD recorder connection Digital connectionVideo Scart connectionVCR STB Audio RGB Audio OUTFor TV and video format VCRSTB Set Top Box For T-V LinkBasic Operations Turn On the PowerAdjust the Volume Select the Source to PlayChanging the Display Brightness Turning Off the Power With the Sleep TimerTurning Off the Sounds Temporarily Activating TV DirectWhen DVD is selected as the source, you can also Input modeOn the remote control Basic OperationsInput ATT indicator Attenuating the Input SignalActivating the Recording Mode Changing the Source NameLoad a Disc Basic DVD Player OperationsOpen the Disc Tray Start PlaybackActivate Realistic Sound Field Select Surround ModeTurn Off the Power into Standby Stop PlaybackTuning into Stations Manually Using Preset Tuning Tuner OperationsSelecting the FM Reception Mode Tuner Operations Using the RDS Radio Data System To Receive FM StationsWhat information can RDS signals provide? Operation ButtonsSearching for a Program By PTY Codes Switching to Broadcast Program Your Choice Temporarily CaseInfo NewsAffairs SportOperation Buttons Basic SettingsOperating Procedure YES ¶ For subwoofer¶ For front speakers, center speaker, and rear speakers Low frequency effect attenuator-LFE Basic SettingsSet the appropriate digital terminal setting Digital input Digital in terminals-DGTOn the display Auto surround-AUTO SRAuto mode-MODE Manual Select the source manuallyPress Control 3 or 2 to adjust Front speaker balance Sound AdjustmentsPress Adjust Adjustment itemsTone-BASS and Treble Adjusting sound from the remote controlFront speaker output balance -BAL balance DAP effect level-EFFECTDTS Digital Surround Creating Realistic Sound FieldsDolby Surround DAP Digital Acoustic Processor modesPossible × Impossible All Channel StereoReflections from behind Early reflections Direct sounds Selecting Surround Modes Activating Surround ModeCreating Realistic Sound Fields Adjust the speaker output levels as follows Adjusting Surround Mode Using Remote ControlAdjust the sound For using test tonePlayable Disc Types DVD Player OperationsDisc Information Discs you can play Disc TypeMenu-driven playback Disc structurePlayback Control function PBC DVD Player Operations Using the On-screen BarEx. When a DVD Video is played Meanings Available discsPress Enter Basic Operation through the On-screen BarPress on Screen twice Changing the Time IndicationFrom the DVD menu Locating a Desired Scene from Disc MenuPress TOP Menu or Menu From the VCD/SVCD menu with PBCPress Angle repeatedly to select the desired view angle Selecting a View Angle-ANGLEPress Angle Press and hold Angle for a few secondsSelecting the subtitle language Changing the Languages-SUBTITLEPress Audio repeatedly to select the desired audio language Selecting the audio channel Press AudioPress Audio repeatedly to select the desired audio channel ST 1 ST 2 L 1 R 1 L 2 RLocating a desired chapter/track- Chapter/Track Search Playing from a Specified Position on a DiscUse the number buttons 0-9 to enter the time Locating a desired position-Time SearchLocating a desired scene-DIGEST Press DigestPress cursor 5/∞/3/2 to move to the desired scene Special Picture Playback Changing the VFP setting-VFP Press cursor 3 or 2 repeatedly to select VFP modeRepeat steps 2 to 4 to adjust other parameters To adjust the appearance of the picturePlaying back in the desired order Program Playback and Random PlaybackRepeat to program the next steps Playing back tracks in random orderRepeating a desired part Repeat PlaybackRepeating a current title, chapter, or all Tracks Special Playback for DVD Audio Activating Surround modeAdditional Information for DVD Audio About indication on the front panelSelecting a still picture Press cursor ∞ or 5 repeatedly to select the desiredPress the number buttons to select a bonus group Playing back a bonus groupLoad an MP3 disc, then press MP3 Disc PlaybackBasic Operations Operations through the MP3 Control Screen Press RepeatLoad a Jpeg disc, then press Jpeg Disc PlaybackSlide-show Playback Operations through the Jpeg Control Screen Press Menu orOperation Buttons Configuration of Choice Menu Choice Menu OperationsPress cursor ∞ or 5 repeatedly To move to on Screen Press Enter to finish the settingPress Choice Press cursor ∞ or 5 repeatedly to select the desired optionPicture menu Choice Menu OperationsLanguage menu AutoJpeg Audio menuMP3 MAXSPK. Setting menu Others menu Select this to deactivate itSetting Parental Lock Restricting Playback by Parental LockReleasing Parental Lock temporarily Changing the setting of Parental LockNew setting is stored Country/Area codes list for Parental Lock Glossary for DVD Player Sound control section Amplifier Operating JVC’s Audio/Video ComponentsOperating Audio Components TunerREW Operating Video ComponentsTV Return Release STANDBY/ON TV Changing the Preset Signal CodesOperating Other Manufacturers’ Equipment Try to operate your TV by pressingRelease STANDBY/ON STB Using the number buttonsEnter the manufacturer’s code Try to operate your STB by pressingRelease STANDBY/ON VCR If there are more than one code listed for your brandOperating Other Manufacturers’ Equipment Try to operate your VCR by pressingCleaning the Unit MaintenanceCleaning Discs General NotesTroubleshooting GenaralFor DVD Player For MP3 TroubleshootingFor Tuner For JpegFM tuner IHF SpecificationsAmplifier AM tunerVictor Company of JAPAN, Limited 0702NHMMDWJEM