12.See step 13. Remove the six M4 x 16mm Screws (66) and the Left and Right Console Covers (109, 110) from the Console (5).
Attach the CD Holder (114) to the Console (5) with two M4 x 12mm Screws (84) as shown.
While another person holds the Console (5) in the position shown, connect the wire harness on the Console to the Upper Wire Harness (86). Insert the excess wire harness down into the Upright (2).
Attach the Console (5) to the Upright (2) with four M4
x12mm Screws (84). Be careful to avoid pinching the wire harnesses.
13.Attach the Left Console Cover (109) to the Console (5) with three M4 x 16mm Screws (66). Attach the Right Console Cover (110) in the same way.
See assembly step 11. Tighten the eight M6 x 16mm Tapered Button Screws (107).
14.Plug the Power Cord (96) into the Power Socket (140) at the rear of the elliptical exerciser.
12 |
|
114 | 5 |
| |
| 84 |
86 |
|
2 |
|
| Wire |
| Harness |
84 |
|
13 |
|
| 5 |
110 |
|
109 |
|
66 |
|
66 |
|
14 |
|
| 96 |
| 140 |
15.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet, place a mat under the elliptical exerciser.
The elliptical exerciser is now fully assembled. If you have purchased the optional chest pulse sen- sor (see page 21), follow the instructions on page 21 and install the receiver included with the chest pulse sensor.
10