Optional Chest Pulse Sensor | ProForm PFCCEL1305.0 instruction

THE OPTIONAL CHEST PULSE SENSOR

The optional chest pulse sensor provides hands-free operation and continuously monitors your heart rate during your workouts. To purchase the optional chest pulse sensor, call the toll-free telephone number on the front cover of this manual.

If you have purchased the optional chest pulse sensor, follow the steps below to install the receiv- er included with the chest pulse sensor.

1.Look under the housing (A) and locate the two recessed screws (B). Remove the two screws, and remove the cover (C) from the housing. Set the cover and the screws aside.

	C
2	91
2
		F
		E
	G	D
	G
		A
Connector	D	B
E
	Small
	Cylinder

2.Gently remove the housing (A) from the Upright (2) and the Water Bottle Holder (91).

3.See the inset drawing. Wrap the wires (D) on the receiver (E) lengthwise around the receiver as shown. Make sure that the wires and the con- nector are not touching the small cylinder.

4.Hold the receiver (E) so the small cylinder is orient- ed as shown, and carefully insert the receiver into the housing (A). Attach the receiver to the housing with the two screws (F) included with the chest pulse sensor.

5.Locate the indicated wires (G) inside of the housing

(A). Pull the end of the wires out of the housing and connect it to the wires (D) on the receiver (E).

Make sure that the connectors snap together.

6.Gently feed the wires into the Upright (2) and insert the housing (A) into the Upright. Be careful to avoid pinching the wires.

7.Reattach the cover (C) and the housing (A) to the Water Bottle Holder (91) with the two screws (B). Note: The wires included with the chest pulse sen- sor are not needed and may be discarded.